Operation; Send; Delete - Accurate Technology IPcam-SD User Manual

S 3 O
ECTION PERATION

Send

To send a position message from the ProScale DRO to the ProRF Receiver,
press the SEND key on the DRO. The DRO will display "Snd" for 1 second.
If the transmission is successful, the MSG SENT LED on the SPC Transmitter
will flash very briefly, about 1/10 second. The ProRF Receiver will momentarily
display the Transmitter ID along with a flash of the POS MSG LED.
Typical SEND button location
(depends on DRO)
Transmitter ID Displayed
If the transmission was not successful, the MSG SENT LED on the SPC
Transmitter will flash for a longer time, about 1 ½ seconds. If this occurs, the
user should try to retransmit again by pressing the SEND key on the DRO. If
the error continues, a range issue or interference may be preventing the
transmission from being received. Move the DRO closer to the Receiver and
attempt the transmission again.
Each time the SEND Key on the DRO is depressed, the SPC Transmitter will
send a new position message to the Receiver.

Delete

The user can also activate a delete function that will transmit a special
message to the ProRF Receiver. This message will cause a delete last
measurement signal to be sent. In the case of a PC, it causes a DELETE text
message to be displayed. To send a delete message, press the F2 Key
NOTE: The delete function only operates with ProScale DROs that have
firmware version 2.x9 or above.
ProRF SPC Transmitter User Manual Page 10 of 12