Accurate Technology IPcam-SD User Manual page 9

Receiver then stores in its permanent memory. Following this operation, the
Receiver will accept messages from any learned Transmitter and reject
messages from unknown Transmitters.
If you purchased this ProRF SPC Transmitter as a system, i.e. with a
ProRF Receiver, the Receiver and Transmitter(s) have already been
associated at the factory during final testing. If you have purchased this
Transmitter separately, you will have to associate it with your ProRF Receiver.
The association procedure is outlined below. Additional information regarding
this operation can also be found in the
To associate one or more Transmitters with a Receiver, complete the following:
1. Connect to the ProRF Receiver using HyperTerminal™ or other
terminal emulation program as described in the ProRF Receiver user's
manual.
2. Enable Transmitter association by issuing the command A1<ENTER>.
The Receiver will indicate that learning is enabled.
3. Insert a paperclip into the hole on the face of the SPC Transmitter
labeled PGM, depressing the small button underneath.
4. The MSG SENT LED
the Receiver will send the following message to the PC: "Transmitter
Learned". The association is now complete.
5. To disable Transmitter association, send the command A0<ENTER>
from the PC to the Receiver. The Receiver will indicate that
Transmitter association is now disabled.
Manual Part # 800-1342-001 Rev 112012
ProRF Receiver user's
should momentarily light on the Transmitter and
manual.
Page 9 of 12