Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Accurate Technology IPcam-SD
- Page 1 ProRF™ Transmitter User Manual...
- Page 2 WARRANTY Accurate Technology, Inc. warrants the ProScale Systems against defective parts and workmanship for 1 year commencing from the date of original purchase. Upon notification of a defect, Accurate Technology, Inc., shall have the option to repair or replace any defective part. Such services shall be the customer's sole and exclusive remedy.
-
Page 3: Table Of Contents
Table of Contents SECTION 1 GENERAL INFORMATION ............4 ................. 4 ANUAL ONTAINS ....................5 NTRODUCTION ProRF SPC Transmitter features ..............5 ....................5 PECIFICATIONS SECTION 2 SET-UP ..................6 RF C ................6 ETTING THE HANNEL RF Channel Switch Settings ............... 7 ................ -
Page 4: General Information
ECTION ENERAL NFORMATION What This Manual Contains This manual includes Set-up and Operation information for: ProRF SPC Transmitter. The ProRF SPC Transmitter is designed to operate with any ProScale Digital Readout (DRO) with an data port. This manual DOES NOT include Set-up and Operation information for ProRF SPC Receiver That manual is available at http://www.proscale.com/Manuals.htm... -
Page 5: Introduction
Introduction The ProRF SPC Transmitter was designed to be used in conjunction with ProScale® measuring systems and the ProRF Receiver. The purpose of this system is to provide a two-way wireless communication channel between any ProScale Digital Readout with a 10 pin SPC output and a computer or other device having an RS232 or USB communication port.. -
Page 6: Set-Up
ECTION Setting the RF Channel The ProRF SPC Transmitter can be configured to operate on 1 of 16 possible radio frequency channels. The default channel is 0. Unless there are other ProRF systems in range that could cause a conflict, the default channel setting of 0 should be used. Note: If the Transmitter’s RF channel is changed from its default setting, the Receiver’s RF channel must also be changed. -
Page 7: Rf Channel Switch Settings
5. Reinstall the battery into the battery holder. PLUS (+) side is When the battery is installed, the two LEDs on the front of the Transmitter will both flash momentarily, then go out. NOTE: If the LEDs continue to flash on and off, remove the battery for 10 seconds and then re-install it. -
Page 8: Connecting The Transmitter
Connecting the Transmitter The ProRF SPC Transmitter is designed to operate with any ProScale Digital Readout (DRO) that has a built in SPC data port. The following illustration uses the General Purpose readout as an example. To install the SPC Transmitter: 1. - Page 9 Receiver then stores in its permanent memory. Following this operation, the Receiver will accept messages from any learned Transmitter and reject messages from unknown Transmitters. If you purchased this ProRF SPC Transmitter as a system, i.e. with a ProRF Receiver, the Receiver and Transmitter(s) have already been associated at the factory during final testing.
-
Page 10: Operation
ECTION PERATION Send To send a position message from the ProScale DRO to the ProRF Receiver, press the SEND key on the DRO. The DRO will display “Snd” for 1 second. If the transmission is successful, the MSG SENT LED on the SPC Transmitter will flash very briefly, about 1/10 second. -
Page 11: Battery Replacement
Battery Replacement Periodically, the coin cell battery in the SPC Transmitter will require replacement. A low battery condition is detected by the Transmitter and will be indicated by flashing the LOW BAT LED when a position message is sent. A low battery condition still allows normal operation but the transmission range may be diminished. - Page 12 Thank you for choosing a ProScale Product, IT WAS PROUDLY MADE IN THE USA Accurate Technology, Inc. 270 Rutledge Rd. Unit E Fletcher, NC 28732 USA 828-654-7920 www.proscale.com Please register your ProScale product. P/N 800-1342-001 Rev 112012 Copyright © 2012, Accurate Technology, Inc. All rights reserved. ProRF SPC Transmitter User Manual Page 12 of 12...