Initial Set Up/Use and Function
3.
Initial Set Up
IMPORTANT : The accessories are stored in the dust
bag compartment and need to be removed before
operating the vacuum cleaner.
1. Unclip the retainer clips on either side of the
vacuum cleaner and lift off to gain access to the
dust bag compartment. (Fig. 3/3).
Fig.3/1
2. Remove the accessories (Fig. 3/2).
Fig.3/2
3. Fit the dust bag by aligning the front of the dust
bag with the inlet slots (Fig. 3/3).
Fig.3/3
4. Position the dust bag to fill the inside of the bin
(Fig 3/4).
Fig.3/4
5. Replace top cover.
4
4.
Use and Function
IMPORTANT: Always remove the power plug from
the wall outlet before assembling or before removing
accessories.
1. Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Push in and twist
clockwise a quarter turn until tight (Fig. 4/1).
Fig.4/1
2. Push the two-piece extension tube onto the end
of the handle (Fig. 4/2).
(Fig. 4/2)
3. Fit the combination floor tool by pushing on to
the extension tubes (Fig 4/3).
(Fig 4/3)