Vectra Fitness On-Line 1650 Owner's Manual page 6

Assembly Instructions
12.
Bolt the leg seat handle/strut/leg developer pivot assembly (K) to the leg/ab seat
bottom (M) (1/4-20 x 3/4 hex screws, qty 4). Attach this assembly to the leg/ab station (D)
such that the hooks on the end of the strut go into the rectangular hole on the top of the
column (D). Line up the 1/2" holes and insert the pivot (1/2" diameter rod and shaft retainers).
Install shaft retainer with a hammer. Bolt the ab seat back/preacher curl cushion (N) to
the leg/ab station (D) (1/4-20 x 3/4 hex screws, qty. 4). FIG. 7.
13.
Attach the leg developer (O) to the leg developer pivot assembly (K) (1/2-13x1
button head screw, qty. 2). Tighten very tight with 5/16" hex key. FIG. 7. Attach the cable
end to the leg developer (O), securing it with plastic hole-plug. FIG. 7A.
O
14.
Attach the bench seat back (P) and bench seat bottom (Q) to the bench
(1/4-20 x 3/4 hex screw, qty. 10). The bench handle installs between cushion
(Q) and the bench frame and is held in place by 2 of these screws. Tighten
firmly. FIG. 8.
FIG. 9
1" Washer
Cotter pin
RIGHT
(cont.)
FIG. 7A
1" Washer
Cotter pin
LEFT
M
K
O
P
15.
Install right cross chest fly arm (arm closest to press station)
on pivot bar. The right arm is the one with the cam at the lowest point
on the arm. Install 1" washer and then cotter pin, bend end. Repeat this
process for the left arm. FIG. 9.
FIG. 7
N
D
23
FIG. 8
Q
handle