1. Manuals
  2. Brands
  3. Vectra Fitness Manuals
  4. Fitness Equipment
  5. On-Line 1650
  6. Owner's manual

Vectra Fitness On-Line 1650 Owner's Manual

Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

F I T N E S S
On-Line
1650
®
Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for Vectra Fitness On-Line 1650

Summary of Contents for Vectra Fitness On-Line 1650

  • Page 1 F I T N E S S On-Line 1650 ® Owner’s Manual...

  • Page 2: Routine Inspection & Maintenance

    4. Inspect press arm adjustment lever for proper function. Ensure that latch pin is engaging the selector shaft prior to lifting. Use only the Vectra supplied pin or a Vectra authorized each position fully. Replace improperly functioning parts with Vectra replacement parts only.

  • Page 3: Cable Diagram

    ® Vectra On-Line 1 650 Cable Diagram Note: The pulleys on this diagram are numbered to make the installation of new cables as easy as possible. Simply start threading the cables through Step 3, Cable Adjustment. the pulleys beginning with the lowest number and See #21 (last working up.

  • Page 4: Assembly Instructions

    Assembly Instructions Select location for your machine. Set machine up in a well lighted and well ventilated Tools Required: area where you will enjoy exercising. Use rubber floor matting or carpet remnants to protect Wrenches: One each (7/16”, 1/2”), two each (9/16”) your floor if desired.
  • Page 5 Assembly Instructions (cont.) Now bolt the press arm lever (I) to the stack column (F) through the bearings. (1/2-13 x 1 button head screws, qty 2). Tighten very tight with 5/16" hex key. Allow the wheels on the bottom of the press arm lever to rest in the "V" of the press arm support. Attach pulley (E) to the press arm lever (I).
  • Page 6 Assembly Instructions (cont.) Bolt the leg seat handle/strut/leg developer pivot assembly (K) to the leg/ab seat FIG. 7 bottom (M) (1/4-20 x 3/4 hex screws, qty 4). Attach this assembly to the leg/ab station (D) such that the hooks on the end of the strut go into the rectangular hole on the top of the column (D).
  • Page 7 Assembly Instructions (cont.) Connect cables to cross chest fly cams. Use plastic hole-plugs in keyholes FIG. 10 to prevent disconnection. FIG. 10A. Install seat bottom (R) (1/4-20 x 3/4 hex screws, qty. 2). Note: If you are installing a leg/calf press option, there are seat handles which install under seat bottom (R).
  • Page 8 Assembly Instructions (cont.) FIG. 13 High pulley height Adjust the high pulley member height now if necessary. Adjust adjusting bolt it up to provide additional pre-stretch for the tallest user, ceiling height allowing. To do this, loosen the bolts that pass through pulley #2 at the top of the main column (C).
  • Page 9 Conditions and Exceptions: Failures due to misuse, abuse, neglect, alteration, improper assembly, repairs other than by an authorized Vectra Service Center, normal wear, damage or lack of maintenance are not covered. Use of a weight stack that is heavier than the heaviest stack that Vectra Fitness sells for use on the machine voids this Limited Warranty.

Table of Contents