Quest Controls BACnet T­Stat User Manual page 9

Setpoints:
Used to set all of the T‐Stats setpoints
Occ Cool Spt: 40‐90 (72)
Occ Heat Spt: 40‐90 (68)
Unocc Cool Spt: 40‐90 (85)
Unocc Heat Spt: 40‐90 (55)
Cool Stg 2 Delta: 1‐9 (2)
Heat Stg 2 Delta: 1‐9 (2)
C/H Min Delta: 2‐9 (4)
User Adjust Max: 0‐5 (5)
Clock: This is used to set the system clock. Use the right arrow key to move to the next field and the
up/down arrow to change the field. Time is entered in 24 hour format. Press the center button to
accept changes.
Schedules: Schedules support two occupied windows per day. The top line will show the day of the
week and either window 1 or 2. Use the up/down arrow keys to change the field's value and the
left/right arrow keys to change to the hours and minutes fields. Time is entered in 24 hour format.
Press the center button to accept the changes to the window and move to the next available window.
You must cycle through all windows to get to the end and complete the programming. It is acceptable
to just press the center button to skip and move on to the next window.
In this example, on Monday morning at 8am the T‐Stat
will switch to the occupied setpoints. This will
continue until 5pm when it will revert to the
unoccupied settings. Since the window 2 time is all
zeros, there will not be a second occupied window for
that day.
In this example, there will be two occupied mode
changes on Monday. The first is from 5am and runs
until 8am and the second will occur at 4:30pm and
continue until 10pm.
Run: Puts the T‐Stat back in run mode
BACnet T‐Stat User's Manual Rev 1.1, 7/28/11 Page | 8