Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for BK Radio DPH- CMD
Summary of Contents for BK Radio DPH- CMD
- Page 1 DPH- CMD DIGITAL PORTABLE RADIO Owner’s Manual BK Radio 7100 Technology Drive West Melbourne, FL 32904 Telephone: (321) 984-1414 FAX: (321) 984-0434 www.relm.com © Copyright 2006 RELM Wireless Corporation. All rights reserved. P/N 7001-30978-200 07-06...
-
Page 2: Table Of Contents
A feature that limits the duration of calls. Transmit Definitions And Acronymns ............... 42 UNAC User Selected Transmit Network Access Code UTGID User Selected Talk Group ID Service ..............Inside Back Cover UTXG User Transmit Channel Guard BK Radio DPH-CMD Owner’s Manual... -
Page 3: Introduction
1. Insert the flexible helical-wound antenna into the radio's antenna connector and turn Commission prior to use. Your BK Radio dealer can assist you in it clockwise until it is firmly seated. meeting these requirements. Your dealer will program each radio with your authorized frequencies, signaling codes, etc., and will be there to... -
Page 4: Rf Energy Exposure Awareness And Control Information
OPERATIONAL INSTRUCTIONS TO ENSURE COMPLIANCE WITH THE FCC’S RF EXPOSURE GUIDELINES. BK Radio battery packs are available in a variety of sizes and types for special applications. Rechargeable battery packs can be charged NOTICE: This radio is intended for use in occupational/controlled separately or while attached to a radio. - Page 5 COMPLIANCE WITH RF EXPOSURE STANDARDS 10. If the download was successful, the Your BK Radio 2-way radio is designed and tested to comply with a display on the Master will again display number of national and international standards and guidelines (listed the clone prompt (target and data to be below) for human exposure to radio frequency electromagnetic energy.
- Page 6 Switch eyes. 4. Put the Master radio in Programming When worn on the body, always place the radio in a BK Radio Mode by pressing and holding the master approved clip, holder, holster, case, or body harness for this product.
-
Page 7: Radio Controls
DPH-CMD Series portable radios can be RADIO CONTROLS programmed with the following features: TRANSMIT INDICATOR BK RADIO DISPLAY BACKLIGHTING SQUELCH SQUELCH ANTENNA CHANNEL GUARD CODE GUARD The DPH-CMD radios can be programmed by ON/OFF VOLUME your dealer to backlight the display when a OFF- signal is received or when a key is pressed. -
Page 8: Basic Operation
PRG TX RX SCN D CMND 2. Talk in a normal voice with the microphone home channel one to two inches from your mouth. T32 N4 3. Release the PTT switch to stop transmitting. Alphanumeric Display Microphone BK Radio DPH-CMD Owner’s Manual... -
Page 9: Channel Guard Operation
Unit-to-Unit call contains the addressee’s NAC, and uses the addressee’s P25 unit ID instead of Channels not programmed with a receive the TGID. Channel Guard value can be used to transmit regardless of carrier activity. BK Radio DPH-CMD Owner’s Manual... - Page 10 Modes: TGID = 0, it will accept incoming group calls containing the “All Call” TGID, and correctly • Busy Channel Indication addressed Unit-to-Unit calls. • Busy Channel Lockout • Busy Channel Lockout with Override BK Radio DPH-CMD Owner’s Manual...
- Page 11 1. Turn the Squelch knob on (clockwise) and monitor the Channel Guard channel before The BK Radio DPH-CMD Series is based on a microprocessor core transmitting, or, if Busy Channel operation is that allows extra features and operational characteristics to be enabled, check the yellow LED.
-
Page 12: Mixed Mode Operation
Talkback Scan is enabled, or the Priority 1 pressing [FCN], then [4] ([FCN] then [G]). channel if TX on PR1 is enabled. TX Mode on The display will show: the RTX channel must be set to MIXED. TGID – 01 XXXXX BK Radio DPH-CMD Owner’s Manual... -
Page 13: Command Group
‘CMND CMND full entered. FULL’. When operating in the Command Group, the continuously rotating channel To enter hexadecimal characters A - F: selector will “stop” at the highest programmed channel. BK Radio DPH-CMD Owner’s Manual... - Page 14 (NXX). Once a UNAC is assigned to Exit the Command Group to add new a particular channel, it will be stored and used channels. with that channel whenever the channel is BK Radio DPH-CMD Owner’s Manual...
-
Page 15: Channel Groups
Repeater Talk Around operation will Repeater Talk Around TALK-AROUND use the pre-programmed RX CxCSS. Group Scan GROUP SCAN Transmit Digital TX DIGITAL If the Source ID is on the caller ID list, the alias will be displayed BK Radio DPH-CMD Owner’s Manual... -
Page 16: Scan Operation
Scan operates only while the radio is not power to return the radio to normal operation. LABEL transmitting. The radio checks for signals on channels in the preset Scan List, as well as the channel selected by the Channel Selector knob. BK Radio DPH-CMD Owner’s Manual... - Page 17 2. Press and hold the PTT switch and talk in blank. a normal voice. Labels are edited from left to right. Pressing the [PRI] key moves the cursor to the next character. Pressing and holding the [PRI] key backspaces to the previous character. BK Radio DPH-CMD Owner’s Manual...
- Page 18 [*] that group is not on the Group Scan List. key is pressed twice, putting the radio in Unit- To-Unit Mode, displaying the last active ID. Missed Call BK Radio DPH-CMD Owner’s Manual...
-
Page 19: Priority Scan
Activity on PR2 preempts is in Unit-To-Unit Mode, regardless of the activity on any of the non-priority channels. position of the ‘TX Digital’ switch. Receptions on PR1 have priority over any other channel, including PR2. BK Radio DPH-CMD Owner’s Manual... -
Page 20: Unit-To-Unit Call
‘selective’, the radio will accept group calls, holds for the duration of the message. The correctly addressed Unit-To-Unit calls, and if RX Incoming Call From display shows the priority channel. Mode is set to mixed, analog signals. Unit on Call List BK Radio DPH-CMD Owner’s Manual... - Page 21 (scan) down, the radio samples the fixed Priority 1 channel. priority channel at the preset rate. If activity occurs on the priority channel, the radio LABEL changes to the priority channel and holds for the duration of the transmission. BK Radio DPH-CMD Owner’s Manual...
- Page 22 NOTES: DPH-CMD Owner’s Manual...
Need help?
Do you have a question about the DPH- CMD and is the answer not in the manual?
Questions and answers