Table of Contents
Advertisement
IMPORTANT NOTE:
such as ROKSAN HDC-02A high definition analogue Cable.
L
O
U
D
S
P
E
A
K
E
R
C
O
L
O
U
D
S
P
E
A
K
E
R
C
O
P l a t i n u m
The
power amplifier utilises very high quality speaker binding post terminals; (5 and/or 6) for the
Left Channel and (7 and/or 8) for the Right Channel. The loudspeakers are connected to the amplifier via these
terminals.
Suitable spade connectors or bare speaker wire can be fitted through the cross-holes of the
amplifier speaker terminals.
Suitable 4mm plugs can also fit through the end holes. Note: 4mm plugs must be EU approoved.
There are two basic types of cable –
•
Figure 8 cable has two insulated conductors which lie parallel, either side by side, or spaced by insulation.
•
Overall sheathed cable has both conductors insulated and enclosed in an overall plastic sheath.
Carefully remove any overal sheath or split the figure 8 cable to a depth of about 75mm (3").
Carefully strip the insulation on each wire to a depth of about 12mm (1/2") exposing the bare core. If the
conductor is stranded, twist the strands together on each conductor.
Unscrew the binding post. There is a cross-hole about 10mm from the panel end of the binding post. Insert the
bared conductor through the hole and tighten the binding post securely making sure that there are no loose
strands or bare ends protruding through the post.
Carefully observe polarity ensuring that the RED (+) speaker terminal is connected to the RED (+) amplifier
terminal and the BLACK/WHITE (-) speaker terminal to the WHITE (-) amplifier terminal.
When both left and right channels are connected to their respective speakers the amplifiers are ready for use.
IMPORTANT NOTE:
For optimum performance it is recommended to use high quality cables such as ROKSAN
HDC-02S high definition Loudspeaker Cable. Many speaker cables such as the ROKSAN HDC-02S are
directional. Please observe this directionality. DO NOT use speaker cable with conductor size less than 16 AWG
(1.6mm Diameter). The Binding posts accept conductor sizes up to 12 AWG.
***
See below:
Standard Single Wired configuration
NOTE:
On both channels, No. (2) Outputs are used.
You can use either No. (1) or No. (2) Outputs.
Roksan Audio ltd
CLASSIFICATION: General Use
All specifications are liable to change without notice. E&OE
For optimum performance it is recommended to use high quality inter-connect cables
N
N
E
C
T
I
O
N
S
N
N
E
C
T
I
O
N
S
LHC
RHC
P l a t i n u m
Page
7
P l a t i n u m
Stereo Power Amplifier User Manual
power
Version 1.03
ENGLISH
Advertisement
Table of Contents
