Self-Diagnosis
The system checks the communication link, monitoring service,
control management and other information of the brick IP
camera automatically.
P leas e log on to t h e c ame ra de vic e
before run nin g s e lf-diagnos is .
Perform the following steps:
1.
Click
Config > Sys Configure >
Device State window, as shown in Figure 61;
F
6 1 D
I G U R E
E V I C E
Note:
If problem that you are unable to solve is encountered,
please feedback the self-diagnosis information to the
factory for our issue tracking.
S
T A T E
Confidential and Proprietary Information of ZTE NETVIEW
Chapter3 Configuration and Operation
Device State to go to
57