Zte NCN 2101-EPI/CE User Manual page 42

SIP port, etc, as shown in Figure 28. Set the IP address of the
camera device as: 192.168.10.62.
F 2 8 I P / P
I G U R E
S ett in g in Te lne t W a y
To set IP information of the brick IP camera by using telnet,
perform the following steps:
1. Click Start > Run at the bottom left of your computer to
open the Run window, as shown in Figure 29. Enter "cmd"
in the Open field, and click OK to confirm.
Note:
After IP address and port are set, restarting the camera
device is required to make the settings become effective.
S
O R T E T T I N G S
Confidential and Proprietary Information of ZTE NETVIEW
Chapter3 Configuration and Operation
29