Table of Contents
Advertisement
Security System Basics
What is a Point?
A "point" is a detection device, or group of devices connected to
your security system. The keypad shows point status through the
lights numbered 1 through 8 on the keypad display. Each point can
represent a single door, window, motion sensor, smoke detector, or
other detection device.
What is a "Faulted" Point?
When a point (such as a door or window) is closed, it is said to be
"normal." When the door or window is open, the point is said to be
"faulted," or not normal. When you turn your system on, you will usually
want all of the points in your system to be normal. You can turn your
system on with faulted points by using the Bypassing Points
procedure.
The keypad shows faulted points by lighting the point status
display (numbered 1 through 8) .
Are All Points the Same?
No. There are two basic types of points, Controlled and 24-hour.
SYSTEM STATUS LIGHTS
ALL
PART
OK
1
2
SOUNDER
4
71-07374-000-B Users Guide.p65
POINT STATUS
TEST
3
4
5
6
7
8
On No Delay
CHECK
WATCH
PART ON
A
4
FUNCTION KEYS
RESET
1
2
3
4
5
6
ALL ON
7
8
9
0
CLEAR
B
C
*
08/21/2001, 1:05 PM
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Security System and is the answer not in the manual?
Questions and answers
I have not used my system in a long time and forgot the passcode
To reset the passcode for a Radionics Security System:
1. Make sure the system is off (the "On" light is off).
2. Press the 5 key. An OK tone will sound, and the display will change.
3. Enter your current passcode. The "Part" light will flash, and your user number will appear.
4. Enter a new passcode with the same number of digits as your old one. If an error tone sounds, return to step 1 and try a different new passcode.
5. Enter the new passcode again. If the OK tone sounds, the system exits change passcode mode. If an error tone sounds, start over.
This answer is automatically generated