Maintenance; Troubleshooting; Limited Warranty - Solar Octane OS6110 Owner's Manual

CAUTION: Make sure charger is unplugged from AC outlet before performing any cleaning or maintenance.
A minimum amount of care can keep your battery charger working and looking good for years.
1. Clean the clamps after each use. Wipe off any battery fluid that may have come in contact with the clamps
to prevent corrosion. Battery fluid may be neutralized with a solution of water and baking soda.
2. Coil the input and output cables neatly after each use. This will help prevent damage to the cables and the
charger.
3. If needed, the case may be wiped clean with a soft cloth.
No ammeter reading (battery does not accept charge).
1. Make sure charger is plugged into live AC outlet.
2. After unplugging unit, check connection at battery. Make sure the clamps are making good contact with
the battery terminal (or vehicle chassis).
3. Check to see that the battery is capable of being charged – it may be damaged or sulfated.
4. Make sure that you have selected the proper charge voltage for the battery being charged.
5. Make sure you are allowing enough time for charging the battery. Refer to the charging time formulas
earlier in this manual.
Ammeter shows reading, but battery does not accept charge.
1. Check to see that the battery is capable of being charged – it may be damaged or sulfated.
2. Make sure you are allowing enough time for charging the battery. Refer to the charging time formulas
earlier in this manual.
Vehicle will not start in engine start mode.
1. Unplug charger and check connections as described above.
2. Determine if charger is charging; if meter indicates any amperage, charger is working; if no amperage is
indicated, wait several minutes and recheck. Charger thermal protector may have tripped.
3. If engine turns over but does not start, problem is with vehicle, not charger. Service vehicle.
See Limited Warranty for further information on obtaining service.

MAINTENANCE

TROUBLESHOOTING

21