Electrical Connection; Wire Connection - Electrolux E30DF7CGPS5 Installation Instructions Manual

30", 36" dual fuel range with electric oven and gas cooktop
Hide thumbs Also See for E30DF7CGPS5:
Table of Contents

Advertisement

Available languages

Available languages

Electrical
Connection
to the Range
This appliance is manufactured
with the neutral terminal
connected to the range.
While connecting range, do not
loosen the nuts which secure the terminal
block to
the range. Electrical
failure
or loss of electrical
connection
may occur.
Note: Refer to the wiring diagram at the end of this
manual.
Three Conductor
Wire Connection
to Range
(The 3-conductor
cord or cable must be replaced with a
4-conductor cord or cable where grounding through the
neutral conductor is prohibited in new installations,
mobile homes, recreational vehicles or in other areas
where local codes do not permit neutral grounding)
If local codes permit connection of the frame
grounding conductor to the neutral
wire of the
power supply cord (Figure 9):
1. Remove the screws
at the lower end of
the rear wire access
panel or cover, then
remove the access
cover or lift the
lower part of the
access panel to
expose range
terminal connection
block (Fig. 7 or 8).
Rear wire
Pressure regulator
access cover
location
Figure 7 - 30" Range
Risk of fire or electrical
shock exists if
an incorrect
size range cord kit is used, if the
Installation
Instructions
are not followed,
or if the
strain relief bracket
is discarded.
2. Remove the 3 loose nuts on the terminal block using
3/8" nut driver or socket.
3. Connect the neutral white wire of the power supply
cord to the center silver-colored terminal of the
terminal block, and connect the other wires to the
outer terminals. Match terminal and power supply
wires by color.
4. Replace the 3 nuts on the terminal block (Figure 9).
5. Replace the rear access cover or panel using the
screws removed on step 1.
Terminal
Terminal
Block
A strainrelief
supplied
1-1/8" Dia. Direct
user must be
Connection Hole.
installed at this Iocatic
Punch out knockout
1-3/8" Dia.
Cord Kit Hole
Figure
9
Three
Conductor
or Wire
Connection
to Range
Rear wire
Pressure
access panel
regulator
location
Figure 8 - 36" Range

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents