Page 1
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal...
Page 2
lrl'_lw'-IttPIl_[ 'PIIStepping, leaning or sitting on the doors Important Notes to the Installer ordrawers of this range can result in serious injuries and Read all instructions contained in these installation can also cause damage to the range. instructions before installing range. Remove all packing material from the oven compartments Do not store items of interest to children...
Locate the Bracket Using the Template - (Bracket may Before Starting be located on either the left or right side of the range. Use Tools You Will Need the information below to locate the bracket if template is For leveling legs and Anti-Tip Bracket: not available).
Page 4
Level and Position Range - Level range by adjusting the (4) leveling legs with a wrench. Note: A minimum clearance of 1/8" is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a spirit level to check you r adjustments.
Page 5
Read electrical connection details below Manual Flare Flexible Flare Union Pressure and connect electricity to range. Shutoff Union Appliance Adaptor Regulator _'lVJV'J:t_ll_[cl Before servicing, disconnect electrical supply at circuit breaker, fuse or power cord. Electric Requirements: An individual, properly grounded and ServiceShut-OffValve ElectricIgnition modelsonly_ (Shownin ON Position).
Page 6
Electric Ignition Surface Burners Operation of Surface Burners Operation of electric igniters should be checked after range Installation of Burner Cap Assembly and supply line connectors have been carefully checked for Your range is equipped with any combination of the sealed leaks and range has been connected to electric power.
Page 7
8. Adjustthe "LOW" Setting of Surface Burner After removing all packing materials and literature from the Valve (Linear Flow Valves Only): oven: Set oven to BAKE at 300°F. See Use & Care Manual for operating instructions. Within 60 seconds the oven burner should ignite. Check for proper flame, and allow the burner to cycle once.
Page 8
If removing the range is necessaryfor cleaning or maintenance, shut off gas supply. Disconnect the gas and electrical supply. If the gas or electrical supply is inaccessible, lift the unit 01_Etri slightly at the front and pull out away from the wall. Pull only Tube as far as necessary to disconnect the gas and electrical supply.