Advertisement
Available languages
Available languages
When connecting to a 4-wire electrical system,
when installing in a mobile home, or when local
codes DO NOT permit connecting the cabinet-
grounding
conductor to the neutral (white)junction
box wire (see Figure 3)
1, Disconnect the power supply.
2, Separate the green (or bare copper) and white
appliance cable wires,
3, In the circuit breaker, fuse box or junction
box:
connect appliance and residence cable wires as shown
in figure 3.
Cable from
Green
Residence
Junction
(or Bare Copper)
Box
White Wire
Green
(or Bare Copper)
White Wire
Wire
(Neutral)
Cable from
Conduit
Appliance
Connector
(or CSA listed)
Figure 3 - 4-Wire Electrical System
(Example: Junction Box)
Improper connection of aluminum
house wiring to copper leads can result in a short
circuit or fire. Use only connectors designed for
joining
copper to aluminum,
and follow the
manufacturer's
recommended
procedure closely.
NOTE TO ELECTRICIAN: The armored cable leads
supplied with this appliance are UL-recognized for
connection to larger gauge household wiring. The
insulation of the leads is rated at temperatures much
higher than the temperature rating of household wiring,
The current carrying capacity of the conductor is
governed by the temperature rating of the insulation
around the wire, rather than the wire gauge alone.
Range
Installation
The electrical power to the range
must be shut off while
line connections are being
made. Failure to do so could result in serious injury
or death.
This range is designed to hang from the countertop,
it
does not rest on the floor.
Be sure the bottom of any wall cabinets are a minimum
of 30" (76,2 cm) above the rangetop area,
To eliminate the hazard or reaching over heated surface
units, cabinet storage space located above the surface
units should be avoided. If cabinet storage is to be
provided, the hazard can be reduced by installing a
range hood that projects horizontally a minimum of 5"
(12.7 cm) beyond the bottom front edge of the cabinets.
1,
Install base cabinets 29" (73,7 cm) apart, and be
sure they are plumb and level before attaching to
countertop.
2,
Cut countertop
exactly as shown in Figure 1. Shave
raised edge level to clear 30" (76,2 cm) wide rim on
rolled edge styled countertops,
3,
Install the wiring,junction
box in an adjoining cabinet
or under the floor (range has 48"/122 cm of
conduit), Cut 1-1/4" (3.2 cm) hole to bring conduit
to the,junction box.
4,
Push the electric conduit through the hole and attach
it to the junction box, Leave enough slack in the
conduit to allow the range to be pulled forward
several inches for service if necessary,
5,
Oven door is heavy. It is advisable to remove door
and eliminate its weight as range is lifted into
position, See oven door removal instructions in the
Use and Care Guide, Lift the range into position on
the countertop.
6,
This range may be equipped with an anti-tip bracket
attached to the back of the range with two screws,
If countertop thickness is greater than 1/2" (1,3 cm),
relocate anti-tip bracket to the lower position 1/4"
(6.4 mm) below (see Figure 1),
7,
Ranges with a lift-up cooktop have 4 anti-tip screws
included in the literature pack (see Figure 4), Lift the
countertop
and secure range burner box to cabinet
with these screws to prevent range from tipping.
4
Advertisement
