Download Print this page
Frigidaire GLED388CSB Installation Instructions Manual
Frigidaire GLED388CSB Installation Instructions Manual

Frigidaire GLED388CSB Installation Instructions Manual

30" electric drop-in range

Advertisement

Available languages

Available languages

Quick Links

INSTALLATION
AND SERVICE MUST BE PERFORMED BY
A QUALIFIED
INSTALLER.
IMPORTANT:
SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
Shave Raised
Edge To Clear
30" (76.2 crn)
Wide Cooktop Rim
1-1/2" Max.
(3.8 cm Max.)
30"
(76.2 cm Min.)
(76.2 cm Min.)
_
--
18" Min.
(4._
Min.)
Locate
Cabinet Doors
1" Min. from
Cut-Out
Opening
*Note:
29" (73,7 cm)
Wide Opening
For Overlapping
Cooktop And
Built-ln Look
Grounded
Junction
Box
in adjoining
cabinet
Do not pinch the power supply cord between the range
and the wall,
Do not seal the range to the side cabinets,
24" Min.
(61 cm Min.)
Smoothtop
Models
ANTI-TIP
AT REAR OF RANGE
48" (122 cm) _
NOTE: Two sets of holes are provided
under
anti-tip
bracket.
Bracket
is
attached in the upper hole position at
the factory.
29" (73.7 cm)
21 3/4" (55.2 cm)
29" (73.7 cm)
*NOTE: Allow at least 20" (50,1 cm) clearance for door
depth when it is open.
**NOTE: 24" (61 cm) minimum clearance between the
cooktop and the bottom of the cabinet when the bottom
of wood or metal cabinet is protected by not less than 1/
4" (0.64 cm) flame retardant millboard covered with not
less than No. 28 MSG sheet metal, 0.015"
(0,4 mm)
stainless steel, 0.024" (0,6 mm) aluminum, or 0.020" (0.5
mm) copper,
26"
_1
1_1/2"
• (66.4 cm)
,I
_.(3.9
ca)
2 -1/2" r--
29-3!6"
(74,6 cm)
30" (76.2 cm) minimum clearance when the cabinet is
unprotected,
22 7/8"_
58.1 cm
1
i
FRONT
OF
CABINET
_1
1/8"
(45.7 cm)
BRe _
* Door open
(see note)
--- ......
;.<
Figure 1
_Recycled
paper
PIN 318201602 (0103) Rev.A
English - pages 1-6
Espar_ol- p4ginas 7-12

Advertisement

loading

Summary of Contents for Frigidaire GLED388CSB

  • Page 1 INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. Shave Raised 30" Smoothtop Models Edge To Clear (76.2 cm Min.) 30" (76.2 crn) Wide Cooktop Rim 1-1/2"...
  • Page 2: Important Safety Instructions

    • Before installing the range in an area covered Important Notes to the Installer Read all instructions contained in these installation with linoleum or any other synthetic floor covering, make sure the floor covering can instructions before installing range, withstand heat at least 90°F above room Remove all packing material from the oven before temperature...
  • Page 3 Electrical This appliance is manufactured with a neutral (white) Requirements power supply wire and a cabinet-connected green (or This appliance must be supplied with the proper voltage bare copper) grounding wire. and frequency, and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or Connect the appliance cable to the junction box through fuse, having amperage as noted on the rating plate (the...
  • Page 4 When connecting to a 4-wire electrical system, Range Installation when installing in a mobile home, or when local The electrical power to the range codes DO NOT permit connecting the cabinet- must be shut off while line connections are being grounding conductor to the neutral (white)junction made.
  • Page 5 Bake-After setting the oven to 350°F (177°C) for baking, the lower element in the oven should become red. Broil-When the oven is set to BROIL, the upper element in the oven should become red. Clean (some models)-When the oven is set for a self- cleaning cycle, the upper element should become red during the preheat portion of the cycle.
  • Page 6 Notes...
  • Page 7 LA INSTALACION Y EL SERVICIO DEBEN SER EFECTUADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. Acepille el borde subido 30" Modelos de superficie lisa 1(76.2cm Min.) ue deje espacio para un borde de 30...
  • Page 8 Manufactured Home Installation 1982 (Manufactured importantes Notas para el instalador Home sites, communities and setups) ; ANSIZ225.1/ Lea todas las instrucciones contenidas en este manual NFPA 501A- ultima ediciOn o con cOdigos locales. antes de instalar la estufa. Saque todo el material usado en el embalaje del •...
  • Page 9 Este aparato est8 fabricado con un alambre electrico Requisitos el_ctricos neutro (blanco) y un alambre verde (o alambre pelado) Este artefacto debe ser suministrado con e! voltaje y la de puesta a tierra conectado al gabinete. frecuencia adecuados, y conectado a un circuito individual correctamente puesto a tierra, protegido por Conecte el cable del aparato a la caja de empalmes por...
  • Page 10 Donde los cbdigos locales NO permitan conectar el Instalacibn de la estufa conductor de puesta a tierra del el_ctrodom_stico al La corriente el_ctrica a la estufa debe neutral (blanco), o si est_ conectado con un sistema a apagarse mientras se hagan las conexiones. Si no se 4 alambres (vea figura 3): hace esto puede provocar dafto serio o muerte.
  • Page 11 Bake/Cocer-Despues de poner el homo a 350°F (177°C) para cocer, el elemento inferior debe ponerse rojo, Broil/Asar-Cuando est8 puesto para BROIL, el elemento superior se debe porter rojo. Clean/Limpieza (algunos modelos)-Cuando el homo est8 puesto para un ciclo de autoqimpieza, el elemento superior se pondr8 rojo durante el perlodo de precalentamiento...
  • Page 12 Notas...