Frigidaire FGF312ASA Installation Instructions Manual page 10

lc. Convert the Pressure Regulator - Non-Self-
Cleaning Standing Pilot Models
a. Remove the cap from the pressure regulator.
b. Remove the plunger fromthe cap.
c. Turn the plunger with the enlarged end down for LP/
Propane use. Turn the plungerwiththesmall end downfor
Natural gas use, (See illustrationbelow,)
d. Replace the plunger inside the cap,
e. Replace the cap.
Q_ CAP
SMALL END _11( _ ENLARGED END
TOWARDS TOWARDS
REGULATOR FOR REGULATOR FOR
NATURAL GAS LR GAS
Oven/Broiler
-- Burner Spud
f.
Remove the thermostat knob toaccess the selector key.
Checkthe selector key on the thermostat to be certain the
pointer is turned to select the proper fuel being used
)lace the thermostat knob.
Oven Gas Selector
Pipe
OFF NAT LP
2. Convert Surface Burner Valves -All Models
a. Liftand lock cooktopto gainaccess tothe surface burner
spuds. Surface burner spuds for models with venturi
burners are located in the front of the burner box. For
models with dual or snap-in burners,the spudsare inthe
bottom of the burnerbox,
b. Using 1/2"wrench, adjustsurfaceburnerspudas follows.
For Naturalto LP/Propane conversiontightenspuddown
clockwise until snug (approximately 2-1/2 turns). This
restricts the flow of gas through the spuds to only that
allowed by the hollow LP/Propane metering pin. Do not
over tighten,
For LP/Propane to Natural conversion, loosen spuds
counter-clockwise (approximately 2-1/2 turns). This
increases the flow of gas around the metering pin.
NATURAL GAS Pl_SPUO,_,,
INCREASE GAS VOLUME
INCREASE FI_'M E SIZE :
L,P, GAS
_&_ DECREASES GAS VOLUME
DECREASES FLAME SIZE
3. Convert Oven Burner Spud
a. Remove oven bottom and oven burner baffle located on
top of burner. To remove oven bottom, remove oven hold
down screws at rear of oven bottom. Pull up at rear,
disengage front to oven bottom from oven front-frame,
and pull the oven bottom straight out of the oven. Remove
nut attaching burner baffle to oven burner.
b. Using 1/2" wrench, adjust oven burner spud as follows.
For Natural to LP/Propane conversion tighten spud down
clockwise until snug (approximately 2-1/2 turns). This
restricts the flow of gas through the spuds to only that
allowed by the hollow LP/Propane metering pin. Do not
over tighten.
,
a,
For LP/Propane to Natural conversion, loosen spuds
counter-clockwise (approximately 2-1/2 turns). This
increases the flow of gas around the metering pin.
Convert Broil Burner
Spud (if equipped)
Using1/2"wrench,adjustbroilburnerspudas follows.For
Natural to LP/Propane conversion tighten spud down
clockwise until snug (approximately 2-1/2 turns), This
restrictsthe flow of gas through the spuds to only that
allowed by the hollowLP/Propane metering pin. Do not
over tighten.
For LP/Propane to Natural conversion, loosen spuds
counter-clockwise (approximately 2-1/2 turns). This
increasesthe flow of gas around the metering pin.
After conversion is complete, follow normal instructions
on page 3 for installation and burner operation/
adjustments. For models with linear flow valves, the low
"simmer" setting must be adjusted after conversion.
10