1. Manuals
  2. Brands
  3. Frigidaire Manuals
  4. Ranges
  5. FGF316ASA
  6. Installation instructions manual

Frigidaire FGF316ASA Installation Instructions Manual

30" gas range
Hide thumbs Also See for FGF316ASA:
Table of Contents

Advertisement

Quick Links

30" GAS RANGE INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
If the information in this manual is not followed
exactly, a fire or explosion may result causing property
damage, personal injury or death.
FOR YOUR SAFETY:
— Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
— Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
Clearances and Dimensions
1. Location—Check location where the range will be
installed. Check for proper electrical and gas supply,
and the stability of the floor.
2. Dimensions that are shown must be used. Given
dimensions provide minimum clearance. Contact
surface must be solid and level.
Français - Pages 11-20
Español - Páginas 21-30
P/N 316259300 (0401)
(For Models with Electric Ignition or Standing Pilot)
Important Notes to the Installer
1. Read all instructions contained in these installation
instructions before installing range.
2. Remove all packing material from the oven compartments
before connecting the gas and electrical supply to the
range.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
Important Note to the Consumer: Keep these instructions
with your owner's guide for future reference.
1
· ALL RANGES
CAN TIP.
· INJURY TO
PERSONS
COULD
RESULT.
· INSTALL
ANTI-TIP
DEVICE
PACKED
WITH RANGE.
· SEE
INSTALLATION
INSTRUCTIONS.

Advertisement

Table of Contents
loading

Related Manuals for Frigidaire FGF316ASA

Summary of Contents for Frigidaire FGF316ASA

  • Page 1 — Installation and service must be performed by a qualified installer, service agency or the gas supplier. Clearances and Dimensions 1. Location—Check location where the range will be installed. Check for proper electrical and gas supply, and the stability of the floor.

  • Page 2: Important Safety Instructions

    Owner's Guide. Before Proceeding: Your range has been preset at the factory for use with Natural or LP/Propane gas. The factory orifice setting is indicated on the serial plate. Be sure the range is adjusted for proper type gas before continuing.

  • Page 3: Before Starting

    1. Anti-Tip Bracket Installation Instructions Important Safety Warning To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed anti-tip bracket and screws packed with the range. Failure to install the anti-tip bracket will allow the range to tip over if excessive weight is placed on an open door or if a child climbs upon it.

  • Page 4: Provide An Adequate Gas Supply

    The gas supply line should be 1/2" or 3/4" I.D. 3. Seal the openings. Seal any openings in the wall behind the range and in the floor under the range after gas supply line is installed. 4. Connect the range to the gas supply.
  • Page 5 Make sure service shut-off valve on pressure regulator is in "ON" position. g) Check for leaks. Turn the gas supply on to the range and use a liquid leak detector at all joints and conduits to check for leaks in the system.
  • Page 6 Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. To check for proper lighting, push in and turn a surface burner knob to the LITE position. You will hear the igniter sparking.

  • Page 7: Air Adjustment

    Operation of Oven Burners and Oven Adjustments 9a. Electric Ignition Burners Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. The oven burner is equipped with an electric control system as well as an electric oven burner igniter.
  • Page 8 30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Electric Ignition or Standing Pilot) 9b. Standing Pilot Oven Burner To light the oven pilot, proceed as follows: Turn the oven thermostat knob to OFF. Remove oven bottom, see step 10 for instructions on removing the oven bottom.

  • Page 9: Gas Conversion

    (For Models with Electric Ignition or Standing Pilot) 12. Make Sure Range is Level. Level the range by placing a level horizontally on an oven rack. Check diagonally from front to back, then level the range by either adjusting the leveling legs or by placing shims under the corners of the range as needed.
  • Page 10 30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Electric Ignition or Standing Pilot) 1c. Convert the Pressure Regulator - Non-Self- Cleaning Standing Pilot Models a. Remove the cap from the pressure regulator. b. Remove the plunger from the cap. c. Turn the plunger with the enlarged end down for LP/ Propane use.

Table of Contents