Frigidaire LTF2140ES1 Installation Instructions Manual page 5

STOP RIB
DRAIN HOSE TABS
SPRING
CLAMP
PROVIDED
ON HOSE
INSTALLATION
Zeve/ing the Washer
Excessive noise and vibration can be prevented by properly leveling the
washer and tightening the leveling leg lock nuts.
1. For free standinq installation and with the washer in it's final position,
place a level on top of the washer. Adjust the leveling legs so the
washer is level front-to-rear and side-to-side, and stable corner-to-
corner. Press down on alternate corners and sides and feel for the
slightest movement. Adjust the appropriate leg so the washer is SOLID
on the floor on ALL four legs. Keep the leveling leg extension ata
minimum for best performance of the washer.
Once the unit is level and
stable in it's final position,turn
the leveling leg lock nuts
against the base of the
washer and tighten with a
wrench.
PUSH HOSE ONTO
COUPLER TO STOP RIB
\\\
\
1
t
/
/
/
/
,
Using pliers, squeeze the ears of the spring clamp
and position the clamp so the clamp ears_ with
and contact the tabs on the drain hose. This as-
sures proper location of the clamp to prevent leaks.
ALIGN SPRING
CLAMP EARS WITH
TABS ON HOSE
J-"
/
"XT
• \\\
\
!
J
/
/
/
t_48S
/
O_ENT _0SE T0
RIGHT_ LEFT_ UP
O_ _DO_ AS _E£DE9
BEFORE iPLACING
¢_,P i_ P_SITION
2.
3.
For pedestal installations remove the Iocknuts from each of the
washer legs. Reinstall each leg threading all the way into the base
(turn each leg tight to the base) before mounting on the pedestal.
See additional installation instructions included with the pedestal.
For undercounter installations the Iocknuts may need to be removed
before installing. Before installing, verify there is enough clearance for
the washer to be installed with the Iocknuts included. If space is not
available, remove the Iocknuts
from the leveling legs and
reinstall each leg by threading
all the way until tight in the
base. Remove the front
service panel and reinstall the
Iocknuts on top of the front
(2) leveling legs inside the
washer and tighten against
the leveling leg bushings once
the unit is in it's final position.
Washer Connections
1. Run some water from the hot and cold faucets to
flush the water lines and remove particles that might
clog up the water valve screens.
2. Remove the inlet hoses and rubber washers from
the plastic bag located in the drum of the washer
and install the rubber washers in each end of the
inlet hoses.
3. Carefully connect the inlet hose marked "HOT" to the outside "H" outlet
of the water valve. Tighten by hand, then tighten another 2/3 turn with
pliers. Carefully connect the other inlet hose to the inside "C" outlet of
the water valve. Tighten by hand, then tighten another 2/3 turn with
pliers. Do not crossthread or over-tighten these connections.
4. Connect the inlet hose ends to the HOT and COLD water faucets tightly
by hand, then tighten another 2/3 turn with pliers. Turn the water on
and check for leaks.
NOTE: Use only new hoses.
ALWAYS ALIGN
OLA_P
_RS
'_ITH T_S 8N HSSE