Frigidaire GLEQ2170KE0 Installation Instructions Manual page 12

Gas & electric dryer
Table of Contents

Advertisement

Available languages

Available languages

Electrical
connection
(non-Canada)
- 4 wire
cord
4-wire receptacle
(NEMA type 14-30R)
- ELECTRICAL SHOCK HAZARD - Failure
to disconnect power source before servicing could result in
personal injury or even death.
1.
Turn off power supply to outlet.
2.
Remove the screw securing the terminal block access
cover in the lower corner on the back of the dryer.
3.
Install a UL-approved strain relief according to the power
cord/strain relief manufacturer's instructions in the power
cord entry hole below the access panel. At this time, the
strain relief should be loosely in place.
4.
Thread an UNPLUGGED, UL-approved, 30 amp. power
cord, NEMA 14-30 type ST or SRDT,through the strain
relief.
5.
Disconnect the internal (BLACK) dryer harness ground
wire from the (GREEN)ground screw next to the terminal
block.
6.
Attach the ground (GREEN)power cord wire to the
cabinet with the ground (GREEN)screw. Tighten the
screw securely.
7.
Move the internal dryer harness ground (BLACK) wire to
the terminal block and attach it along with the neutral
(WHITE) power cord wire conductor to the center, SILVER
colored terminal on the terminal block. Tighten the screw
securely.
8.
Attach the RED and BLACK power cord conductors to
the outer, BRASScolored terminals on the terminal block.
Tighten both screws securely.
- ELECTRICAL SHOCK HAZARD - Do not
make a sharp bend or crimp wiring/conductor
at connections.
9.
Follow manufacturer's guidelines for firmly securing the
strain relief and power cord.
10. Reinstall the terminal block cover.
-- Neutral
',WHITE wire)
Line 2
BRASS terminal)
Neutral
(SIWER terminal)
Line 1
(BRASS terminal)
Internal ground
(GREEN screw)
...............
_
Install
UL-approved
strain relief here
Terminal
screw
recovery
slot
If a terminal screw falls during cord installation, it
can be retrieved in the terminal screw recovery slot below the
access panel.
Move internal ground (BLACK)
neutral (SILVER)
wire to for 4-wire system.
"_h
terminal
/
|
"\\\
GREEN
ground screw
Neutral
terminal
WHITE
neutral wire
GREEN
ground wir,
BLACK or
RED power wir
BLACK
or RED
power wire
12

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gleq2170ks0

Table of Contents