Unpacking - Frigidaire GLER341CC0 Installation Instructions Manual

TOP CONSOLE MODELS
ROUGH-IN DIMENSIONS
267/8'
(68.3 cm)
[_]" ELECTRIC CONNECTION
2 9/16"i--_
(6.5 cm)
13 112" _,a
(34.4cm ]
0
T L-.J
33/4'
(9.5 cm)
I
435/8'
(I 10.7cm)
318" (0.96 cm) DIA.
GAS PIPE I' (2.54 cm)
REAR VIEW
(91.5 cm)
47 1/2"
(120.7 cm)
DOOR OPEN 90 o
1
4 3/8"
(11.1 cm) ---_
OPTIONAL
VENT KNOCKOUT_, "
L.--I
27'
(68.6 cm)
SIDE VIEW
L__j ¸
3 3/4"
(9.5 cm)
UNPACKING
1. Using the four shipping carton corner posts (two on each
side), carefully Iaythe dryer on its left side and remove foam
shipping base.
_To prevent damage, do not use the control panel
as a means to pick up or move the dryer.
NOTE: On under counter model clothes dryers, the top panel
may be removed for installation.
2. Returnthedryertoan upright position.
_ ING
REVERSING DOOR SWING
Your dryer is designed so the door swing may be reversed at
any time without additional parts. Conversion is accomplished
by transferring hinges to the opposite side of the cabinet.
To change the direction of the door opening:
1. Open the dryer door. Removethe four hinge hole plugsfrom
the left side of the door opening. Place nearby for future
installation. NOTE: You may need a plastic knife to help pull
out the plugs. Be careful not to scratch the paint.
2. Remove the four screws that secure the door hinges to the
dryer front panel (see below). NOTE: Remove one screw
from each of the two hinges first. Hold the door firmly before
removing the last two screws.
3. Rotate the door 180 ° and reinstall the door hinges to the
dryer front panel with the four screws.
4. Install the four hinge hole plugs in the open screw holes on
the right side of the door opening.
REMOVE 4 SCREWS
HONE FROM EACH
INGE FIRST)
6