Advertisement
Installation
Instructions
ADDING DUCT FOR EXHAUST THROUGH
BOTTOM OF CABINET
• Insert the 4" straight duct in the elbow end hanging out
of the dryer bottom. Wrap duct tape around the joint.
CAUTION:
Be sure not to pull or demege the
electrical
wires inside the dryer when inserting
the duct.
ADDING COVER PLATE TO REAR OF
CABINET
Connect standard metal elbows and ducts to complete
the exhaust system. Cover buck opening with a plate (Kit
WE1M454) available from your local service provider. Place
dryer in final locution.
-_WARNING-NEVER
LEAVE THE
BACK OPENING WITHOUT
THE PLATE
(KIT WEIM454).
[]
CHANGING
DIRECTION OF DOOR
OPENING
REMOVE/4
HOLE P LUGS AND
REMOVE/4
PLACE THEM INTHE HOLES
HINGE SCREWS,
ON THE OPPOSITE
SIDE,
ROTATE
DOOR 1 80 °
AND REINSTALL.
i_ISERVICING
-_kWARN ING-LABEL
ALL WIRES
PRIOR TO DISCONNECTING
WHEN
SERVICING CONTROLS. WIRING
ERRORS CAN CAUSE IMPROPER AND
DANGEROUS OPERATION AFTER
SERVICING/INSTALLATION.
REGISTER YOUR NEW APPLIANCE TO RECEIVE ANY
IMPORTANT PRODUCT NOTIFICATIONS.
Please go to www.GEAppliances.com
or moil in
your product registration
card.
For questions
on installation,
coil: 800.626.2000
(US) or
800-561-3344 (Canada).
Advertisement
