Installing The Anti-Tip Bracket - GE JSP46 Installation Instructions Manual

Installation Instructions
Installing the Anti-Tip Bracket
_-_ Locating The Bracket
a. Decide whether the bracket will be
installed on the right or left side of range
opening.
b. Place the bracket as shown in Fig. 1.
ADJACENT CABINET 3_"
/ WALL (_hih_
FLOOR-WOOD /
BRACKET
BIDE
REAR
LEG
FLOOR-CONCRETE
Fig. l
Installing The Bracket in Wood
or Concrete
INSTALLATION-WOOD CONSTRUCTION
a. Locate the centers of the four holes identified
in Fig. 1 as Floor-Wood and Wall.
b. Drill a 1/8" pilot hole through the pre-marked
areas. Note the angle of the wall screw in
Fig. 2.
c. Mount the Anti-Tip bracket with the four
screws provided.
ATTACHMENT TO WALL
TO FRONTEDGE
OF _
25"_
COUNTERTOP
BRACKET
SCREW MUST
WALL
PLATE
OR METAL
Fig. 2
INSTALLATION-CONCRETE CONSTRUCTION
a. For concrete installation you will need two
1/4"x 1-1/2" lag screws, and two sleeve
anchors.
b. Locate the center of the four holes identified
in Fig. 1 as Floor-Concrete and Wall. Drill
the recommended size holes in each.
c. Install the sleeve anchors into the predrilled
concrete holes and install the lag and wall
screws through the Anti-Tip bracket. Make
sure the screws are securely tightened.
8