Select Unit View>Appliance>Appliance Settings>User Accounts>LDAP>Search. The Appliance LDAP
1.
Search page appears.
NOTE:
is enabled on the LDAP Overview
Configure the Search parameters:
2.
Search DN—Defines the administrator-level user that the target device uses to log into the directory
o
service. Once the target device is authenticated, the directory service grants it access to the
directory to perform the user authentication queries specified on the LDAP query page. The default
values are cn=Administrator, cn=Users, dc=DomainName, and dc=com. Each search value must
be separated by a comma.
Search Password—Used to authenticate the administrator or user specified in the Search DN field.
o
Search Base—Defines a starting point from which all LDAP searches begin. The default values are
o
dc=yourDomainName and dc=com. Each search value must be separated by a comma. For
example, to define a search base for test.com, your values are dc=test, dc=com.
UID Mask—Specifies the search criteria for user ID searches of LDAP target devices. The format is
o
<name>=<%1>. The default value is sAMAccountName=%1, which corresponds to Active
Directory.
LDAP query
To configure LDAP query parameters:
The LDAP Search and Query parameters can only be configured if LDAP Authentication
("Configuring
LDAP" on page 49) page.
Configuring the console switch 51