Install The Range - GE JSS28 Installation Instructions Manual

Installation Instructions
INSTALL THE RANGE
Ill ANTI-TIP DEVICE INSTALLATION
An Anti-33p bracket is supplied with
instructions for installation in a variety of
locations. The instructions include all
necessary information to complete the
installation. Read the Safety Instructions
and the instructions that fit your situation
before beginning installation.
Bracket_ Wall plate
S ......... t _ 1 [ _
"_ enter wood .........................
__1_ or metal
I.J, J/ I I ................................................................................
Typical installation of anti-tip bracket attachment to wall
-4,WARNING:
• Range must be secured by Anti-'lip bracket
supplied.
• If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB2X7909.
• See instructions to install (supplied with
bracket).
• Unless properly installed, the range could be
tipped by stepping or sitting on the door.
Injury may result from spilled hot liquids
or from the range itself.
SLIDE RANGE INTO OPENING
[] On models with a power cord, plug it into
the receptacle. Locate the cord in the back
of the range in a manner that it will not
touch or be moved by the drawer.
Position range cord so that
there is no interference with
storage drawer
I Storage drawer 1
\ •
\
\
/ \
\ /
\
\
\
/ \
/ /
[] Carefully push the range into the opening.
[]
[]
[]
[]
LEVEL THE RANGE
Install the oven shelves in the oven and
position the range where it will be
installed.
Check for levelness by
placing a spirit level or
a cup, partially filled
with water, on one of
the oven shelves. If
using a spirit level, take
two readingsiwith the
level placed diagonally first in one
direction and then the other.
The front leveling legs can be adjusted
from the bottom and the rear legs can be
adjusted from the top or the bottom.
I_ II _ Lower
range
Use an open-end or adjustable wrench
to adjust the leveling legs until the range
is level.
10