GE JSS28 Installation Instructions Manual page 11

Installation Instructions
_-I REPLACING THE OVEN DOOR
NOTE: The oven door is heavy. You may need
help lifting the door high enough to slide it
into the hinge slots. Do not lift the door by
the handle.
[] Lift the oven door by
placing one hand on each
side. The door is heavy, so
you may need help. Do not
lift the door by the handle.
[] With the door at the same angle as the
removal position (halfway between the
closed and broil stop position), seat the
notch of the hinge arm into the bottom
edge of the hinge slot. The notch of the
hinge arm must be fully seated into the
bottom of the slot.
Hinge arm
Bottom
edge of slot
Hinge notch
[] Open the oven door as far as it will open.
[] Push the hinge locks up Hingein locked
position
against the front frame of \
the oven cavity, to the I '_---"
locked
Notch of hinge
position,
securely fitted
into bottom of
hinge slot
[] Close the oven door.
[] REPLACING THE STORAGE
DRAWER
[] Place the drawer
rail on the _,
guides.
[] Push the drawer
in until it stops.
[] Lift the front of
the drawer and
Stop
push in until the stops clear the guides.
[] Lower the front of the drawer and push in
until it closes.
SPECIAL INSTRUCTIONS IF YOU ARE
HAVING PROBLEMS WHILE REPLACING
THE STORAGE DRAWER
If drawer won't close:
Drawer front
Drawer does panel tipped
not close Rear drawer away from
completely I _ support is body s de
Powerbe obstructingC°rd may , I_ resting on top -- _1 14
I drawer in this area IIIW_I of guide rail !_UIi'_
Remove and replace, making sure the power
cord is not obstructing the drawer and/or the
rail is in the guide.
If drawer is crooked:
Rear drawer
support is on top Drawer front panel
of guide rail on
the high side I_ tipped to one side
J
Remove and replace, making sure the rail is in
the guide.
11