XTS DVR72XX-S User Manual page 97

Please refer to the following sheet for detailed information.
Parameter
Ethernet
DHCP
TCP Port
HTTP Port
UDP Port
Max Connection
Remote Multiple
Host cast
group
PPPOE
Email
The email interface is shown as in
Figure 7-32
Function
Please select the network card first.
Dynamically get IP address. You can get the device IP from
the DHCP server if you enabled this function.
Default value is 37777.
Default value is 80.
Default value is 37778.
Network user max amount. The value ranges from 0 to 10.
O means there is no user can access current device.
Set MULCAST address and port.
Enable MULCAST function.
Input the PPPoE user name and password you get from the
IPS (internet service provider) and enable PPPoE function.
Please save current setup and then reboot the device to
get the setup activated.
Device connects to the internet via PPPoE after reboot.
You can get the IP address in the WAN from the IP address
column.
Please note if you want to reboot the device please make
sure you have proper reboot right and there is no login user
in current device.
F igure 7-33 .
X 4 6 3 H 4 6 3 H 4 6 3 H 4 6 7 H X
97