Monogram ZFSB25DSS Installation Instructions Manual page 9

Installation Instructions
[STEP 6] LEVEL THE REFRIGERATOR
Tile refl'igerator can be leveled by ;Mjusting the rollers
located near the bottom hinges.
Raise
Rollers
Rollers have three purposes:
* Tile rollers ac!iust so that the door closes easily when
opened about halfwa> (Raise the fl'ont about 5/8"
[l 6 mm] fl'om tile floor.)
* Rollers at!just to allow the refl'igerator to be firmly
positioned on the floor and to prevent rocking
when tile doors are opened and closed.
* Tile rollers allow you to move the refl'igemtor fi'om
the wall for cleaning.
To Adjust the Rollers:
Roller Adjusting Screw
• Use a 3/8" hex socket or wrench to turn the
ac!justment screws. Turn the screws clockwise to
raise the refligerato_; turn cotmterclockwise to
lower it.
RollerAdjustingScrews
ZFSB25 rear rollers cma also be adjusted.
• Use a 5/16" hex socket to turn the screws fl)r the
rear rollers. Turn the screws clockwise to raise the
refl_igerator, counterclockwise to lower it.
[STEP 7] LEVEL THE DOORS
If tile doors are not evenly aligned at the top, the
refl'igerator door can be a(!justed.
• Use a 7/16" hex socket or wrench to turn the door
a(!justing screw. Turn the screw to the right to raise
the (loo_; ttu'n left to lower the door.
Align at Top
NOTE: A nvhm plug is imbedded in the threads of
the pin. The plug is designed to prevent the pin fl'om
tm'ning. A wrench must be used to tm'n the pin.
• Turn tile wrench one or two times. Open and close
the refl'igerator door to check alignment with the
fl'eezer door at the top. A(!just again if necessarv_