Page 1
Installation And Sa Full Size Tumble Action Washer Before beginning instaliation_ carefully read these instructions. This will simplify installation and ensure the washer is installed correctly and safely. Leave these instructions near the washer after installation for future reference. NOTE: The electrical service to the washer...
Page 2
AND MARK THE MACHINE "OUT OF ORDER", UNTtLTHE INTERLOCKSYSTEM ISREPAIRED,AND OPERATESAS DESCRIBEDABOVE. If you have questions regarding operation of this machine, or proper testing of the door interlock system, contact GE Service at 1-800-GE CARESor www.GEAppliances.com. To reduce the risk of fire, electrical shock, or injury to persons when using this washer, comply with th.e basic warnings listed below.
Page 3
INSTALLATION AND SAFETY INSTRUCTIONSmanual are not meant As an ENERGY STAR ¢Partner, to cover every possible condition and GE has determined that this product situation that may occur. Common meets the ENERGY STAR® sense and caution must be practiced guidelines for energy efficiency.
Page 4
receptacle is present, it is the owner's PRE-INSTALLATION REQUIREMENTS responsibility to have a licensed electrician replace it with a properly grounded three prong Tools Required for Installation: grounding type receptacle. 1. 1/4 in. nut driver 3/8 in. socket with ratchet. WATER SUPPLY REQUIREMENTS 3/8 in.
Page 5
ROUGH-IN DIMENSIONS (3.8t) Power Cord 331/2 (85) SIDE Adjustable Legs inch (cm) (91.5) Under Counter (87.9) Roller Wheels...
Page 6
LOCATION OF YOUR WASHER 7. Remove the service panel from the front of the DO NOT INSTALL YOUR WASHER: washer. In an area exposed to dripping water or outside 8. Remove the 4 nuts and 6 large washers that attach weather conditions.
Page 7
INSTALLATION Run some water from the hot NOTE: If the drain hose is placed in a standpipe and cold faucets to flush the without forming a U shape, a siphoning action water lines and remove could occur. There must be an air gap around particles that might clog up the drain hose.
Page 8
If replacements parts are needed for your washer, contact is placed, MUST be at least 1/2 inch the source where you purchased your washer or call 1-800-GE CARES for the GE Authorized Parts Distributor larger in diameter than the drain hose. This will insure that the sewer line nearest you.