GE JGP633 Installation Instructions Manual page 14

Installation Instructions
MAKING THE LP CONVERSION (CONT.)
[]
[]
[]
CHANGE COOKTOP BURNER
ORIFICES
Remove the top grates,
burner caps, and burner
heads.
Remove the spark
igniters from the burner
base (if required to
access the orifices).
Using a No. 15 "Torx"
head driver bit, remove
the screws holding the
burner base in position.
Remove This
,!Assembly
Orifice Spud Located
Through This Opening
Using a 7mm nut driver,
remove the top burner
orifices. These may be
accessed through the
hole in the cooktop.
Burner cap
Burner
Spark igniter base
18,000 BTU Burner
(on some models)
_Burner
Burner head
base
Spark igniter
r_ CHANGE COOKTOP BURNER
ORIFICES (CONT.)
On most burners,
the orifices have a spring-
loaded retaining ring around
the hex head to hold the
orifice in the nut driver during
installation and removal. A
_ etainer
Ring
slight amount of force is required to push the nut
driver down over the ring.
NOTE: For orifices that do not have a spring-
loaded retaining ring, use pliers to hold the orifice
in position during initial thread
engagement or final removal to
avoid dropping the orifice in the
cooktop. Then use the nut driver
to tighten or loosen.
14