Making The Lp Conversion - GE JGP633 Installation Instructions Manual

Installation Instructions
MAKING THE LP CONVERSION
IF SOLD OUTSIDE THE U,S, AND CANADA:
A WARNING: ifyou wish t ouse this
product
with Liquefied Petroleum (LP) gas containing greater
than 10% butane, you must purchase a butane
conversion kit. To order, please call 1.888.664.8403 or
1.787.276.4051.
Model Butane Kit #
JGP970
WB28TI0229
ZGU36
PGP966 WB28T10283
JGP633 WB28T10235
TOOLS YOU WILL NEED
FOR LP CONVERSION
Phillips-Head 7mm Nutdriver
Screwdriver
Pliers
No. 15 Torx-Head
Driver
Small Flat-Head
Screwdriver (4mm or
5/52" tip size, 60mm or
Safety Glosses 2-3/8" long)
r_ SAFETY INFORMATION YOU
SHOULD KNOW
The pressure regulator and burner orifices are set
for natural gas. To use LP gas, the regulator and
burner orifices must be converted. The LP orifice
spuds for the cooktop burners are attached to
the regulator along with separate LP conversion
instructions.
A CAUTION:
The cooktop, as shipped from
the factory, is set for use with natural gas. If you
wish to use your cooktop with LP gas, you must
first replace the orifices and convert the pressure
regulator.
A WARNING:
Thisconversion must
be performed by a qualified installer or gas supplier
inaccordance withthe manufacturer's i nstructions
and all codes and requirements of the authority
having jurisdiction. Failure to follow instructions could
result in serious injury or property damage. The
qualified agency performing this work assumes
responsibility for the conversion.
A CAUTION:
The following
adjustments
must be made beforeturningon the burner.
Failure to do so could result in serious injury. Be
sure pressure regulator has been converted as
described in Step 2.
[2]
B]
E1
ADJUST YOUR COOKTOP FOR USE
WITH LP GAS
Disconnect all electrical power, at the main
circuit breaker or fuse box.
Shut off the gas supply to the cooktop
by closing the manual shut-off valve.
Adjust the pressure regulator, by the following
instructions:
, Unscrew the cap.
, Carefully look at the spring retainer to locate
the NAT or LP position.
Cap Gasket_
N_ LP
NAT, _fE_ L.P./Propone
Position Position
Pressure Regulator
. Turn the spring retainer over by rotating it
90 deg., pull it from the cap, turn the spring
retainer over so that LP is showing, insert it
back into the cap, and then rotate it 90 deg.
into position.
. Screw the cap back onto the regulator and
tighten.
13