GE JGP633 Installation Instructions Manual page 15

Installation Instructions
r_ CHANGE COOKTOP BURNER
ORIFICES (CONT.)
[]
Locate the LP orifices attached to the
regulator along with separate LP conversion
instructions. They will have a digit for size,
and a letter for type of gas, on the top or
side. (Important: Save the orifices removed
from the appliance for future use.)
Each orifice will show a series of engraved
marks, (I, II, III, X or none), located on the top.
These marks denote the precise location of each
orifice to the cooktop burner.
0000
15,000 BTU/HR Burner (on some models)
O he 15,000 BTU/HR burner has two orifices with
markings located in the sides only. (See rating
plate on bottom of appliance).
NOTE: The main orifice is located low in the center
of the burner while the simmer orifice is located
higher behind the center of the burner.
Simmel_
orifice
Mainorifice
JGP633
PG P966
JGP970 &
ZGU36K
Main: 99 HXL
Simmer: 34 SL
[]
Install the LP orifices in their precise locations
as noted in the illustrations above.
Return the natural gas orifices to the bracket
and reattach the bracket and the instruction
sheet to the pressure regulator using the
screw removed previously.
Replace the burner bases, heads, caps and
top grates. (NOTE: When re-attachinq the
burner bases to lass to units tiqhten screws
to a maximum of 10 in.-Ibs tar uaueJ.)
15