Vision Fitness T60 Owner's Manual page 7

Hide thumbs Also See for T60:

Table of Contents

T R E A D M I L L T 6 0

ASSEMBLY STEPS

ATTENTION: After installation is completed, the treadmill will need to be calibrated by

using the AUTO-CHECK function. If this is not done, the treadmill's speed and incline

values may be incorrect and damage the treadmill. DO NOT stand on the belt when

performing the AUTO-CHECK function.

STEP 1: Remove The Motor Cover

Unscrew the left and right-size screws (Z53) and lift the motor cover off the treadmill

and set it aside.

Z53

STEP 2: Secure The Left And Right Console Mast

a.Attach the left console mast by placing it into the console mast support bracket and

aligning the mounting holes.

b.Lift up the plastic piece (Q05) that is attached aside the motor cover. Place 3 screws

(Z50) on the outside and 1 screw (Z50) on the inside and secure the screws, but leave

room for adjustments.

c.Place a wave washer (Z51) on the screw (Z50) and secure the screw in the front of the

console mast.

d.Put the plastic piece (Q05) down. Place 2 screws (Z53) and secure the screws into the

frame.

e.Secure the right console mast to follow the above procedure.

Diagram 1

T R E A D M I L L T 6 0

Table of Contents

Show Quick Links

Table of Contents