Quickie Revolution Owner's Manual page 32

Chair adjustments
Rear axle positions
Seat height
The seat height (Fig. 34) is
adjusted by removing the axle
clamp (1) and the camber bar (2).
Remove the two retaining screws
(3) and nuts (4), using a 4mm Allen
key and an 10mm A/F spanner, and
adding an axle spacer (5), using
the screws and nuts (6) provided in
the kit. The screws and nuts must
be tightened to 8-10Nm torque. The
spacers are available in 19mm and
38mm sizes.
Note: both axle spacers must
be positioned in the
corresponding holes on both
sides of the frame to ensure the
chair's centre of gravity is
correct.
Rear axle positions
Wheelbase width
The wheelbase width (Fig. 35) is
adjusted by loosening the 28mm A/F
axle sleeve nut (1), and screwing
the axle sleeve (2) in or out. The
nut must be tightened to 45Nm
torque.
Revolution
2 1 4
Fig. 34
1
Fig. 35
28
6
3 5
2
Issue 5