Quickie Revolution Owner's Manual page 29

Chair adjustments
Backrest angle
The backrest angle (Fig. 28) is
adjusted by loosening the eccentric
bolt assembly (1) using a 4mm
Allen key and the pivot bolt (2)
using a 4mm Allen key sufficiently
to allow the eccentric assembly to
be rotated. When the desired
position is reached tighten the
eccentric bolt fitting and pivot bolt in
the recessed position to 7-12Nm
torque.
Backrest height
Remove the upholstery and remove
the retaining screws and washers
(Fig. 29), using a 5mm Allen key (1)
from both sides of the backrest
tube (2). Move the inner tubes (3)
to the desired position, carefully
aligning the holes in both tubes and
refitting the retaining screws and
washers. Tighten to 7-12Nm
torque.
Issue 5
Fig. 28
2
1
Fig. 29
25
2 1
3
Revolution