Quickie Revolution Owner's Manual page 27

Chair adjustments
Footplate height
To adjust the fooplate height
(Fig. 25) loosen the two footplate
screws (1), sufficiently to allow the
tubes (2) to slide in or out of the
footplate. (Use a 5mm Allen key).
Remove both screws (3), using a
4mm Allen key, and move the tubes
up or down to the required position,
carefully aligning the holes on the
tubes with the holes in the frame
(4). Replace both screws and
tighten to 7-12Nm torque.
Warning:
The screws (3) also connect the
front frame (4) and the castor
housings (6) to the lower frame
tubes (5). When loosening the
screws ensure the castor housing is
kept in its original position.
Footplate position
To adjust the fooplate position
(Fig. 26) remove the two footplate
screws (1) and nuts (2). Turn the
footplate (3) through 180
both screws and nuts and tighten to
7-12Nm torque using a 4mm Allen
key.
Issue 5
O
replace
23
4
2
1 2 3
Fig. 25
1
3 2
Fig. 26
5
6
Revolution