Download Print this page

IKEA ICR500XB00 Installation Instructions Manual page 8

Hide thumbs Also See for ICR500XB00:

Advertisement

Available languages

Available languages

3-Wire Cable from Home Power Supply to 3-Wire Cable
from Cooktop
- U.S. only
IMPORTANT: Use the 3-wire cable from power supply where local
codes permit connecting the frame-ground
conductor to the
neutral (white) junction box wire.
B
C
G
H
A. Red wires
B. Bare or green wire from
cooktop
C. 3-wire cable (from cooktop)
D. Junction
box
E. White wire (from power supply)
F. UL listed wire connector
G. Black wire
H. UL listed or CSA approved
conduit connector
1. Connect the 2 black wires together using the UL listed wire
connectors.
2. Connect the 2 red wires together using the UL listed wire
connectors.
3. Connect the green or bare cooktop cable wires to the white
(neutral) wire in the junction box using the UL listed wire
connectors.
4. Install junction box cover.
NOTE: This section applies only if you are using clamp brackets.
G
ii
i
F
ii...............................................
E
IliZ
A. Glass cooktop
B. Cooktop base
C. Attachment
screw
D. Clamp bracket
(extends far enough beyond
cooktop base to alllow installation
of clamping screws)
E. 2Y2" (6.4 cm)
clamping screw
F. Countertop
G. Foam seal
1. Place the 21/2 '' (6.4 cm) clamping screws into the brackets.
2. Check that the cooktop is still level.
3. Use a flat-blade screwdriver to tighten the screws against the
countertop.
Do not overtighten.
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all your tools.
3. Dispose of/recycle all packaging materials.
4. Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by protective shipping
material. Dry thoroughly with a soft cloth. For more
information, see the "Cooktop Care" section of the
Use and Care Guide.
5. Read "Cooktop Use" in the cooktop Use and Care Guide.
6. Reconnect power.
NOTE: If the cooktop does not work after turning on the power,
check that a circuit breaker has not tripped or a household fuse
has not blown. See "Troubleshooting"
section in the Use and Care
Guide for further information.
If you need Assistance
or Service:
Please reference the "Assistance
or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your cooktop.

Hide quick links:

Advertisement

loading