Corinex Intelligent PowerNet Owner's Manual page 18

4
Troubleshooting Guide
3. Check that the devices exist on the network.
Start the PowerNet Setup Tool Program, click 'Next'
and see if all devices on your network are found. If
all devices are listed, skip this section. If a device is
missing:
4. Check that the
Ethernet Adapters devices are detected by TCP/IP.
From the command prompt, run ping and type the
computer name or IP address of the computer you
are working on. [ping yourcomputername] This
should return 4 good packets. Now try to ping
Press the normal/uplink button on the
Corinex Intelligent
Adapter.
Try a different Ethernet cable with the
normal/uplink button in both positions.
Make sure all computers have only one
active network slot
Make sure
PowerNet
plugged straight into the wall and not
through a power strip or extension cord.
Unplug all Corinex Intelligent PowerNet
Ethernet Adapters and plug them back
in again, one by one. Run the PowerNet
Setup Tool Program again.
The devices may be programmed with
different passwords. Setup all devices
with a new password as described in the
PowerNet Setup Tool Manual.
The chosen outlet pair may have poor
electrical connection, try a different pair
of outlets.
Corinex Intelligent PowerNet
PowerNet
the Corinex
Ethernet Adapters
Ethernet
Intelligent
are
17