Advertisement
CONNECT EQUIPMENT TO UPS
Now connect your load to be protected (computer, monitor etc.)to the AC Output receptacles at the rear of
the UPS.
MAINS
OUTLET
¡ î Do not connect a surge suppressor, or extension cord to the UPS outlet.
¡ î Do not connect a Laser printer or any non-computer peripherals to UPS outlets.
LASER PRINTER
MAINS
OUTLET
Enable the UPS by turning on the Power ON/OFF switch, which is situated on the front panel.
POWER
The UPS is now ready to use. Switch on your equipment and you are ready to function.
BATTERY MAINTENANCE/BATTERY CHARGING AFTER SHIPMENT FROM THE FACTORY THE BATTERY
NEEDS RECHARGING. IF NOT USED FOR A LONG PERIOD OF TIME, THE BATTERY WILL START
SELF-DISCHARGING, WHICH MAY RESULT IN A SHORT SERVICE LIFE OF THE BATTERY OR MAY EVEN
CAUSE DAMAGE TO IT DURING WARRANTY PERIOD. CARE SHOULD ALSO BE TAKEN TO AVOID
EXCESSIVE TEMPERATURE AROUND THE UPS, WHICH COULD ALSO RESULT IN REDUCING SERVICE
LIFE OF THE BATTERY. TO ACHIEVE MAXIMUM SERVICE LIFE FROM THE BATTERY THE ABOVE
INSTRUCTIONS SHOULD BE FOLLOWED.
The UPS battery charges whenever the UPS is connected to utility power & is switched ON. It typically requires
less than eight hours to charge fully. Operating runtime is reduced until the battery is fully charged.
TEST THE UPS
To test UPS on battery back-up, switch off utility supply and observe 'backup Indicator' lights. Also your PC
should continue to function normally.
3
Advertisement
