1. Manuals
  2. Brands
  3. Olympia Manuals
  4. Cordless Telephone
  5. OL3020
  6. Owner's manual

Olympia OL3020 Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

OLYMPIA
OL3020
®
OWNER'S MANUAL
MANUAL DEL USARIO

Advertisement

Table of Contents
loading

Related Manuals for Olympia OL3020

Summary of Contents for Olympia OL3020

  • Page 1 OLYMPIA OL3020 ® OWNER’S MANUAL MANUAL DEL USARIO...
  • Page 2 First Edition: June 2004 Trademark Information ® Olympia is a registered trademark of Olympia International Holdings Ltd. ® InfoGlobe is a registered trademark of Wave Industries, Ltd. Disclaimer The information contained in this document is subject to change without notice.

  • Page 3: Table Of Contents

    Mute .......................31 Changing Volume.....................31 Part II InfoGlobe Operation................32 InfoGlobe Features ...................32 InfoGlobe Control Keys ...................32 Getting Started....................33 Normal Standby Mode..................33 Pre-programmed Messages................34 Demonstration Mode ..................35 Time & Date .....................36 Daylight Saving Time..................37 Personal Messages....................37 Erase All Memories ..................39 OL3020 User Manual...
  • Page 4 Caller ID ......................39 Setting Timer On/Off..................41 Troubleshooting the InfoGlobe.................42 Part III Consumer Information ........´ í Î ó £ ¡ Î ´ ¶ ¨ Ò å Ê é Ç © ¡ £ OL3020 User Manual...

  • Page 5: Important Safety Instructions

    If liquid has been spilled into the product. iii) If the product has been exposed to rain or water. iv) If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the OL3020 User Manual...
  • Page 6 13. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electrical shock from lightning. 14. Do not use the telephone to report a gas leak in the vicinity of the leak. OL3020 User Manual...

  • Page 7: Safety Instructions For Battery Pack

    SAFETY INSTRUCTIONS FOR BATTERY PACK CAUTION: Danger of explosion if battery is incorrectly replaced. Use only an Olympia Phone approved battery pack in the handset of your Cordless Telephone. To reduce the risk of fire or injury, always do the following when replacing, discarding, or charging the battery.

  • Page 8: Part I Cordless Phone Operation

    Selective erase / ‘Erase All’ functions Real time clock (date & time) Private/ out-of-area indication LCD display contrast control (6 levels - default at 3) ‘Smart Dialing from Caller ID ‘Battery Low’ indication on the Handset display OL3020 User Manual...

  • Page 9: Set Up

    Follow the steps listed above, or press MEM. repeatedly to find the feature you wish to program. Once you program the desired feature, press MEM repeatedly to exit programming (CONTRAST is the final programming option prior to exiting programming mode). OL3020 User Manual...

  • Page 10: Installation And Charging Of The Battery Pack

    Close the battery compartment. You may change the face panel with one of the color options provided. Plug the power and telephone cords into the corresponding jacks on the bottom of the Base. Run the cords through the channels provided. OL3020 User Manual...

  • Page 11: Layout Of Keys And Indicators

    10. The CHARGE indicator on the Base glows when the Handset is charging. Maximum talk time on a full charge is 4 hours. Maximum standby time on a full charge is 5 days. Your results may be somewhat less that these maximums. Layout of Keys and Indicators OL3020 User Manual...

  • Page 12: Powering Up

    In the event you do not receive the visual and audible indicators, check to ensure the Base is powered and the battery pack is connected. Return the Handset to the Base cradle. Answering Calls The incoming call is signaled by a ringing sound from the Handset and by the OL3020 User Manual...

  • Page 13: Make A Call

    Press and hold down the ‘PAGE’ key on the Base Unit. ‘PAGING’ will be shown on the LCD display and your Handset will beep. If you hold the button for 5 seconds, the page will be extended to 60 seconds. Press any key on the Handset to stop paging. OL3020 User Manual...

  • Page 14: Selecting System Language

    ‘000’ (if it is not already programmed for ‘000’). Press ‘MEM.’ key to confirm. After confirmation, ‘SET T/P ? is displayed. 15 Setting Tone/Pulse (Preset to Tone) S E T T / P ? T OL3020 User Manual...

  • Page 15: Setting Ringer On/Off

    To change the AM/PM setting, press any digit. Press ‘▼/#’ or ‘▲/*’ to skip forward or backward. Press ‘MEM.’ key to confirm. After confirmation, you will enter CONTRAST setting. 18 Setting Display Contrast OL3020 User Manual C O N T R A S T 5 6...
  • Page 16 20 seconds, you will be returned to idle mode. Display contrast can also be set by pressing ‘FLASH’ during standby (idle) mode: Press ‘▼/#’ or ‘▲/*’ to set the desired contrast. Press ‘MEM.’ to confirm. After confirmation, the display returns to standby mode. OL3020 User Manual...

  • Page 17: Caller Id Operation - Handset

    1. Shows the real time clock (AM/PM format), or, 2. The time stamp of a CID record. Clock ticker Blinks when real time clock is being displayed. Date 1. Shows the date (month/date format), or, 2. The date stamp of a CID record. OL3020 User Manual...
  • Page 18 The NEW CALL indicator will flash. Once you review all new CID records, the NEW CALL indicator turns off. NEW CALL 10:00 1 1/0 1 CALL The display also indicates if caller information is not available or intentionally blocked by the sender: OL3020 User Manual...
  • Page 19 ‘▼/#’, the LCD displays the latest new call information. 1 0/3 0 10:00 CALL Repeatedly press ‘▲/*’ or ‘▼/#’ to review all new call information in the order of receipt until the LCD displays ‘END NEW CALL’ and the ‘NEW CALL’ indicator stops blinking. OL3020 User Manual...
  • Page 20 In standby mode, press ‘▲/*’ or ‘▼/#’ to review old call information from the oldest to the newest (‘*’ button) or from the newest to oldest (‘#’ button). 10:00 1 0/3 0 CALL When the end of the list is reached, ‘END’ is displayed. -- E OL3020 User Manual...
  • Page 21 If the new call information has been reviewed, you can erase all call records. If there are any new calls in call list, ‘ERASE ALL’ will not work. In the standby (idle) mode, press and hold ‘DELETE’ until the LCD displays ‘ERASE ALL?’. OL3020 User Manual...
  • Page 22 “123”. 1) Press ‘CALLS’; it will change to 8 digits: ‘1-456-7890’. 2) Press ‘CALLS’ again; it will change to 10 digits: ‘123-456-7890’. 3) Press ‘CALLS’ again; it will change to 11digits: ‘1123-4567890’. OL3020 User Manual...
  • Page 23 Press ‘CALLS’ to select the number format that you want to save. iii. Press ‘MEM.’ The screen will display ‘LOCATION ? X’, where X is a digit (0-9). Note: only the phone number can be saved to speed dial memory. OL3020 User Manual...

  • Page 24: Visual Message Notification - Handset

    NOTE: most, but not all service providers can provide this notification service. After receiving a ‘new message’ signal from your service provider, the envelope icon will appear, alerting you that you have new message(s). 10:00 1 0/3 0 CALL OL3020 User Manual...

  • Page 25: Speed Dial Memory (0

    Programming is completed! CAUTION: Make sure you’re not replacing an important phone number already in that location! 2. Memory editor Enter memory search mode by pressing ‘MEM.’. Press ‘▼/#’ or ‘▲/*’ to select the memory location you want to edit. 10:00 10/19 M E M 2 OL3020 User Manual...
  • Page 26 Press ‘FLASH’ to clear all entered digits (including any pre-existing digits). Press ‘MEM.’ to save the entered number. The display will show ‘LOCATION? X’, where X is a digit (0-9) OL3020 User Manual...
  • Page 27 To exit memory search mode without dialing, press ‘CHAN.’ to return the display to standby. No activity for 20 seconds will return the Handset to standby mode. OL3020 User Manual...

  • Page 28: Pre-Dialing (Handset Off)

    22 Pre-dialing (Handset OFF) You can enter a phone number while in the standby mode. The maximum number of digits is 24. For example, enter number 0: 10:0 1 0/3 0 Enter number 1: 1 0/3 0 10:0 OL3020 User Manual...

  • Page 29: Redial With Handset Off

    Press ‘FLASH’ to clear all entered digits and return to standby. Press ‘TALK’. The unit will enter TALK mode automatically. The number will scroll across the screen from right to left as it is dialed. OL3020 User Manual...

  • Page 30: Dialing Digits

    Timer The call timer comes up automatically when you are in TALK mode, on the 3 line of the display. After 10 seconds, the call timer will appear as dialing activities are completed. 1 0/3 0 10:00 OL3020 User Manual...

  • Page 31: Battery/Voltage Low Detection

    28 Changing Volume You can adjust the volume level (3 levels) in TALK mode. Press ‘DELETE’ (VOL +) to increase the listening volume or ‘CALLS’ (VOL -) to decrease the listening volume while you are on a call. OL3020 User Manual...

  • Page 32: Part Ii Infoglobe Operation

    Press to exit menu and return to standby. SELECT Press to enter into menu selection. Use UP/DOWN keys to locate desired setting. Press to confirm a menu entry. Press again after confirmation to go back to main menu. OL3020 User Manual...

  • Page 33: Getting Started

    There are 5 New Calls in Call Log Details of Latest Caller ID record Timothy 1-866-537-0384 Note: When there are no CID records in the Call Log, OLYMPIA INFOGLOBE is displayed as part of the normal standby mode rotation. Message Waiting...

  • Page 34: Pre-Programmed Messages

    Pre-programmed Messages Daily and Year-round Holiday/Special Occasion Greetings: Good Morning During 00:00 ~ 11:59 (12:00AM ~ 11:59AM) Good Afternoon During 12:00 ~ 16:59 (12:00PM ~ 4:59PM) Good Evening During 17:00 ~23:59 (5:00PM ~ 11:59PM) Year-round Holiday/Special Occasion Greetings OL3020 User Manual...

  • Page 35: Demonstration Mode

    Happy Thanksgiving Day after Thanksgiving Happy Holidays to December 28 December 29-31 New Year’s Day Happy Holidays Wishing You A Prosperous New Year Demonstration Mode This allows the user to view a selection of displays. This includes: OL3020 User Manual...

  • Page 36: Time & Date

    Use UP or DOWN to select SET DATE TIME in the menu. Press SELECT again. The Month (or Day) field is blinking. Use UP or DOWN to select the correct Month (or Day). Press RIGHT to move to the next location. OL3020 User Manual...

  • Page 37: Daylight Saving Time

    DST: OFF (or ON) The ON/OFF field is blinking. Press UP or DOWN to toggle between ON and OFF. Press SELECT to confirm your selection. Note: The default value after a power failure is DST: Off.. Personal Messages Programming Personal Messages OL3020 User Manual...
  • Page 38 To set the message date, use LEFT and RIGHT to toggle between Month and Date. The chosen field will blink; use UP and DOWN to program the desired Month and Date. Press SELECT to confirm message frequency; you are now ready to enter your message. OL3020 User Manual...

  • Page 39: Erase All Memories

    The last Caller ID received will be the first to be shown in the list. • When the Caller ID list is full the oldest Caller ID is automatically deleted and the most recent Caller ID is added. OL3020 User Manual...
  • Page 40 04>11/04 12:30am - Message Waiting No CID data; a Message was left with your voicemail service. 05>11/04 12:30am - MW 186-653-7038 Message Waiting and Number available. 06>11/04 12:30am - MW 123-456-7890 David Jones Message waiting; Name and Number OL3020 User Manual...

  • Page 41: Setting Timer On/Off

    Use the RIGHT key to move to the locations for setting the ‘Timer OFF’ time in the same manner as above. Confirm the setting by pressing SELECT. Note: Caller ID information will not be received when the InfoGlobe is turned off. OL3020 User Manual...

  • Page 42: Troubleshooting The Infoglobe

    3. Floating display looks faint. Check that AC adapter has been plugged in properly. Place unit against a dark background to obtain maximum illumination from floating display. OL3020 User Manual...
  • Page 43 If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer. According to telephone company reports, AC electrical surges, typically resulting OL3020 User Manual...
  • Page 44 STOP!!!! If you are having trouble with your product or have any questions, DO NOT return it to your dealer. Call our Help Desk at 1-866-537-0384 for assistance. OL3020 User Manual...
  • Page 45 Wave, or products purchased more than 12 months previous. This warranty gives you specific rights. You may also have other rights, which vary from state to state. OL3020 User Manual...

Table of Contents