Advertisement
Available languages
Available languages
Method
B - To permanently
connect
to house-
hold
or field
wiring:
1. Remove the dishwasher electrical supply
junction
box
cover and connect to the power supply cord from the
house installation. See Figure 5.
Figure 5
2. Remove 2" to 3" (51 - 76ram) of the outer casing of the
household or field supply wiring as shown in Figure 6.
Remove 3/8" to 1/2" (10 - 13ram) of the insulation from
each wire as shown in Figure 6.
Hot Water
Supply
The hot water heater should be set to deliver approximately
120° F (49° C) water to the dishwasher. Water that is too hot
can cause some detergents to lose effectiveness. Lower water
temperatures will increase run times. The hot water supply
pressure must be between 15- 145 psi (1 - 10 bar).
IM PORTANT
NOTES:
*
If using a solder joint instead of a compression fitting, be
sure to make all solder connections before connecting
the water supply line to the dishwasher.
*
Make sure there are no sharp bends or kinks in the water
line that might restrict water flow.
.
Always use the appropriate
seal when making plumbing
connections.
.
Before connecting
the water supply line to the dish-
washer, flush the incoming water line for approximately
5 minutes to clear any foreign material.
.
Turn on the water supply and check for leaks after
connections are made.
Figure 6
I
_---
2"-
3"
---_-I
I
(51ram
- 76ram)
I
3/8"-
1/2"
1_
41[
(lOmm-
13mm)
3. Insert the bare copper
or green wire(ground)
to the
"G"
ground connection
"___L" of the terminal
block
and securely
tighten
the terminal
block screw (see
Figure 5).
4. Insert the white (neutral) wire to the "N" connection
of
the terminal block and securely tighten the terminal block
screw.
5. Insert the black(hot) wire to the "L" connection
of the
terminal block and securely tighten the terminal block
screw.
6. Check all electrical connections to make sure they are
secure and then attach the junction box cover with the 4
screws.
Avoid Electrical
Shock Hazard
To avoid
possible
injury
or property
damage,
care should be exercised when the dishwasher
is
installed
or removed
to reduce the likelihood
of
damage to the power cord.
Avoid
Scald Hazard
Do not perform
any work
on a charged
hot water
line.
Serious
injury
could
result.
Only
qualified
plumbers
should
perform
plumbing
work.
Do not
attempt
any work
on the
dishwasher
hot
water
supply
plumbing
until you are certain
the hot water
supply
is shut off.
Temperatures
required
for
soldering
and
sweat-
ing will
damage
the
dishwasher.
If plumbing
lines
are
to be
soldered
or sweated,
keep
the
heat
source
at least
6 inches
(152.4
mm)
away
from
the dishwasher.
Connecting
the
Hot
Water
Supply
There are two plastic corrugated hoses that exit the back of
the dishwasher. The larger hose, with the brass fitting on the
end, is the water supply hose to the dishwasher (the other
hose is the dishwasher drain hose). You will need a 3" x 1:s/4 ' '
(76 x 45ram) opening through the cabinet to pass the dish-
washer water supply line through toward the shut off valve.
8
Advertisement
