Table of Contents
Advertisement
Getting Started
To connect your handset to your laptop or other
device with a serial data cable:
1 Open the flap covering the handset's accessory
connector.
2 With the handset's display facing up, insert the
serial data cable's connector into the accessory
connector, until you hear a click.
3 Insert the data plug into the COM port of your
laptop or other device.
Make sure no other application is using the COM port
selected.
Make sure the COM port settings of your laptop or
other device are set to the following:
• Bits per second: 4800
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: Hardware
To set your handset to send location information to
your laptop or other device:
connector
cover
1 From the main menu, select GPS > Interface.
2 Set NMEA OUT to On.
Your handset is now sending location data to your
laptop or other device.
To stop your handset from sending location data to
your laptop or other device:
Set NMEA OUT to Off.
Each time you power your handset on, NMEA OUT is
automatically set to Off.
Using GPS with Map Software
167
Advertisement
Table of Contents
