Asus CUSL-L 815 microATX User Manual page 26

3. HARDWARE SETUP
17) USB Headers (12-1 pin USB2)
If the USB Ports on the back panels are inadequate, a USB header is available
for two additional USB ports. Connect the 12-1 pin ribbon cable from the pro-
vided 2-port USB connector set to the midboard 12-1 pin USB header and mount
the USB connector set to an open slot on your chassis.
CUSL-L
CUSL-L USB Header
18) ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT:
Make sure that your ATX power supply (minimum recommended
wattage: 200 watts; 235W for a fully-configured system) can supply at least 20
amperes on the +5-volt lead and at least 10mA (750mA recommended) on the +5-
volt standby lead (+5VSB). Your system may become unstable/unreliable and may
experience difficulty in powering up if your power supply is inadequate. For Wake-
On-LAN support, your ATX power supply must supply at least 750mA +5VSB.
CUSL-L
CUSL-L ATX Power Connector
USBPORT
2
1
CUSL-L User's Manual
12
11
25