Asus CUSL-L 815 microATX User Manual page 24

3. HARDWARE SETUP
12) Power Supply (PS_FAN), CPU (CPU_FAN), Chassis (CHA_FAN) Fan
Connectors (3 pins)
These connectors support cooling fans of 350mA (4.2 Watts) or less. Orientate
the fans so that the heat sink fins allow airflow to go across the onboard heat
sink(s) instead of the expansion slots. Depending on the fan manufacturer, the
wiring and plug may be different. The red wire should be positive, while the
black should be ground. Connect the fan's plug to the board taking into consid-
eration the polarity of the connector.
WARNING!
The CPU and/or motherboard will overheat if there is no airflow
across the CPU and onboard heatsinks. Damage may occur to the motherboard
and/or the CPU fan if these pins are incorrectly used. These are not jumpers,
do not place jumper caps over these pins.
CUSL-L
CUSL-L 12-Volt Cooling Fan Power
13) Internal Audio Connectors (4-pin CD1N, MODEM)
These connectors allow you to receive stereo audio input from such sound sources
as a CD-ROM, TV tuner, or MPEG card. The MODEM connector allows the
onboard audio to interface with a voice modem card with a similar connector.
CUSL-L
CUSL-L Internal Audio Connectors
CHA_FAN
CDIN (Black)
Right Audio Channel
Left Audio Channel
Left Audio Channel
VIDEO (Green)
MODEM Modem-Out
Modem-In
CUSL-L User's Manual
CPU_FAN
PS_FAN
Ground
Ground
Right Audio Channel
Ground
Ground
23