Download Print this page

Amana AGR5844VDB4 Installation Instructions Manual page 4

30" (76.2 cm) freestanding gas ranges
Hide thumbs Also See for AGR5844VDB4:

Advertisement

Mobile Home - Additional
Installation
Requirements
The installation of this range must conform to the Manufactured
Home Construction
and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD Part 280). When such standard is not
applicable, use the Standard for Manufactured
Home
Installations, ANSI A225.1/NFPA 501A or with local codes.
Mobile home installations
require:
When this range is installed in a mobile home, it must be
secured according to the instructions
in this document.
Product Dimensions
A
B
C
E
A. 27z_ '' (70.8 cm) max. depth with handle
B. 36" (91.4 cm) cooktop height (max.) with leveling legs
screwed aft the way in*
C. 46 z_,,(119.1 cm) overall height (max.) with leveling
legs screwed all the way in*
D. 29 z_'' (75.9 cm) width
E. 25 z_,, (64.6 cm) depth. Back of range to front of
cooktop**
F. Model/serial
rating plate (located on the oven frame
behind the top left side of the oven door)
IMPORTANT:
Range must be level after installation. Follow the
instructions in the "Level Range" section. Using the cooktop as
a reference for leveling the range is not recommended.
*Range can be raised approximately
1" (2.5 cm) by adjusting
the leveling legs.
**Front of door and drawer may extend further forward,
depending
on styling.
Cabinet
Dimensions
Cabinet opening dimensions shown are for 25" (64.0 cm)
countertop depth, 24" (61.0 cm) base cabinet depth and
36" (91.4 cm) countertop height.
IMPORTANT:
If installing a range hood or microwave hood
combination
above the range, follow the range hood or
microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.
L
*NOTE: 24" (61.0 cm) minimum when bottom of wood or metal
cabinet is covered by not less than 1/4"(0.64 cm) flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the
cooking platform and the bottom of an uncovered wood or metal
cabinet.
A. 18" (45.7 cm) upper side cabinet to countertop
B. 13" (33 cm) max. upper cabinet depth
C. 30" (76.2 cm) min. opening width
D. For minimum clearance to top of cooktop,
see NOTE*.
E. 30 _" (76.5 cm) min. opening width
F. The shaded areas are recommended
for installation of rigid
gas pipe.
G. 4½" (11.4 cm)
H. 8" (20.3 cm)
I. 17" (43.2 cm)
2.2" (5.1 cm)
K. 4½" (11.4 cm)
L. 2" (5.1 cm) min. clearance from both sides of range to side
waft or other combustible
material.
M. Grounded outlet
N. Cabinet door or hinges should not extend into the cutout.

Advertisement

loading