MK Diamond Products MK-2000 PRO Series Owner's Manual & Operating Instructions page 29

MAINTENANCE AND TROUBLESHOOTING
6. Movable Cutting Table Wheel Change Out:
NOTE: All four (4) Movable Cutting Table, Roller Wheels should be replaced at the same time (MK Diamond
Part No. – 133090)
(A)
Remove the Movable Cutting
Table
(D)
Clean the Roller Wheel Shaft
Holes in the Movable Cutting
Table before installing new
Roller Wheels
Roller Wheels
(G)
Lubricate the Roller Wheels
using light oil
(Such as WD-40, 3 in 1, etc.)
MK-2000 Pro
Movable
Cutting Table
Place the Movable Cutting
Table on a Workbench with the
Roller Wheels facing up
Washer
Roller Wheel
Clean Holes
Install the Wheel/Washer
Assembly into Movable Cutting
Table Wheel Shaft Hole
Lubricate
Remove the Movable Cutting
Revision 01/02, Effective Date January 10, 2002
Roller Wheels
(B)
(E)
Movable
Cutting Table
(H)
Table
Rotate counter-
clockwise to loosen
1/2-Inch Wrench
(C)
Using a 1/2-inch wrench, remove
the Roller Wheel Retaining Nut
and the Roller Wheel
Rotate clockwise
to tighten
1/2-Inch Wrench
(F)
Install the Roller Wheel
Retaining Nut and tighten using
a 1/2-inch wrench
Page 29