MK Diamond Products MK-2000 PRO Series Owner's Manual & Operating Instructions page 20

SETUP, ADJUSTMENT and OPERATION
Cut in smooth even strokes; do not force the saw to cut.
Position Masonry
Piece below Blade
(G)
Position the Masonry Piece
below the Blade
ON/OFF
Switch
(K)
Turn the Saw off when cutting
is complete
3. Cutting with the Cutting Head Locked Down:
This method is preferred when cutting small objects.
Cut in smooth even strokes; do not force the saw to cut.
Note: Skip steps H and I, if cutting dry.
Turn counter-
clockwise to loosen
Locking Handle
(A)
If locked, loosen the Cutting
Head Locking Knob
MK-2000 Pro
Hold Masonry
Stationery
Lower the Cutting Head to
begin the cut
OFF
Position
Lower the Cutting Head until the
Blade touches the Protective
Wooden Strip
Revision 01/02, Effective Date January 10, 2002
Lower
Smoothly
to Cut
(H)
Continue lowering the Cutting
Head until the cut is complete
Lower Cutting
Head
(B)
Continue to Lower
Cutting Head until
Cut Complete
(J)
raise the cutting head when
the cut is complete
Turn clockwise
to tighten
Locking Handle
(C)
Lock the Cutting Head in the
"Down" position using the
Locking Knob
Page 20