MK Diamond Products PX-3 PAVER XTREME Owner's Manual page 5

on
MAKE THE WORKSHOP KID PROOF
on
Make the workshops kid proof by using padlocks, master switches or by removing starter keys.
DO NOT FORCE THE TOOL
A power tool will do a job better and safer operating at the rate for which it was designed.
on
USE THE RIGHT TOOL
Do not force a tool or an attachment, to do a job that it was not designed to do.
USE THE PROPER EXTENSION CORD on
If using an extension cord make sure it is in good condition first. When using an extension cord, be sure
to use one heavy enough to carry the electrical current your product will draw. An undersized extension
on
cord will cause a drop in line voltage that will result in a loss of power and overheating. TABLE 1, Page
9 shows the correct AWG size to use depending on cord length and nameplate ampere rating. If in on
on
doubt, use the next heavier gage. The smaller the gage number, the heavier the cord.
USE PROPER APPAREL
on
Do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry that may be caught in
moving parts. Non-slip footwear is recommended. Wear protective hair covering to contain long hair.
ALWAYS USE SAFETY GLASSES
Safety glasses should always be worn when working around power tools. In addition, a face,
dust mask or respirator should be worn if a cutting operation is dusty. Everyday eyeglasses
only have impact resistant lenses and may not prevent eye injury-they are NOT safety glasses.
SECURE WORK
Clamps or a vise should be used to hold work whenever practical. Keeping your hands free to operate
a power tool is safer.
DO NOT OVERREACH
Keep proper footing and balance at all times by not overreaching.
MAINTAIN TOOLS WITH CARE
Keep tools clean for the best and safest performance. Always follow maintenance instructions for
lubricating, and when changing accessories.
DISCONNECT TOOLS
Power tools should always be disconnected before servicing or when changing accessories, such as
blades, bits, cutters, and the like.
REDUCE THE RISK OF UNINTENTIONAL
Make sure the ON/OFF switch is in the OFF position before plugging in a power tool.
on
PX-3
on
START
Revision 01/04, Effective Date January 23, 2004
SAFETY
5