MK Diamond Products PX-3 PAVER XTREME Owner's Manual page 20

MAINTENANCE AND TROUBLESHOOTING
DIAMOND BLADE CHANGE OUT
Change the Diamond Blade when it becomes worn, cracked, or damaged. The following section describes the
correct procedure for changing out the Diamond Blade.
WARNING
!
Disconnect the tool before servicing and when changing accessories, such as blades, bits, cutters, and
the like.
(A)
Unplug the PX-3 from its
Power Source
20
Remove Retaining Nut and
(D)
Install the Diamond Blade
onto Blade Shaft. Ensure that
it is seated properly on the
Flange.
Revision 01/04, Effective Date January 23, 2004
(B)
Outer Flange
Install the Retaining Nut and
Outer Flange and then tighten
using the Blade and Shaft
Wrenches
(C)
Remove Diamond Blade from
Blade Shaft
(E)
PX-3